Lava Computer 2SP-550 User Manual 2

Lava 2SP-550

Installation Manual

SERIAL2

1

SERIAL

T

POR

PARALLEL

MADE
IN

CANADA

LAVA COM PUT ERS

LAVA2SP

P.N.MOKO L37.5

Rev.B00

Hardware Set-Up

Serial 2 Settings

Serial 1 Settings

Serial IRQ Settings

Serial Settings

COM 1

(03F8h)*

Default for

Serial1

COM 2

(02F8h)**

Default for

Serial2

Serial IRQ Settings

Parallel Settings

COM 3

(03E8h)

COM 4

(02E8h)

Serial 2

Serial 1

34211 7 51215 10

Parallel Mode Settings

16C552

LPT 1

(0378h)

(default)

LPT 2

(0278h)

Bi-directional

Serial 2

Serial 1

Parallel Port

Parallel Settings

IRQ 5

IRQ 7

(default)

Parallel

Mode Settings

(default)

Output

2SP-550 Configuration

Serial Configuration

1. Determine the number of serial ports installed in your system. Each serial
port will have an unique "COM" designation.Configure the ports of the 2SP­550 for two unused COM addresses.

2. Determine which IRQ's (interrupts) are free in your system.Configure each
serial port on the 2SP-550 for an unused IRQ. Although some devices allow
sharing of IRQ's, this is not recommended.

3a. For Serial 1, install the jumper above the number corresponding to the

desired IRQ, so that it covers the pin in the bottom row and the pin in the
middle row.

3b. For Serial 2, install the jumper above the number corresponding to the

desired IRQ, so that it covers the pin in the top row and the pin in the middle
row.

Do not install more than one IRQ jumper per serial port.

Parallel Configuration

1. Determine the number of parallel ports installed in your system. Each parallel
port will have an unique "LPT" designation. Configure the port of the 2SP­550 for an unused LPT address (e.g.If you have a parallel port installed as LPT
1 using hexidecimal address 0378, configure the 2SP-550 as LPT 2 using
address 0278h).

2a. Configure the parallel port for an unique IRQ, if required.Many applications

do not require an IRQ assignment for operation.Consult the documentation
accompanying your software and/or operating system.

2b. Typically, a parallel port configured for LPT 1 at address 0378h, will be set for

IRQ 7 and a port configured for LPT 2 at address 0278h, will be set for IRQ 5.

3. The 2SP-550 supports two parallel modes: Output (SPP, 4-bit,"nibble") & Bi­directional (8-bit, "byte," PS/2 compatible).

Note: To disable a port,remove the jumper from both of the IRQ and

the corresponding COM or LPT jumper configuration pins.

Lava

Technical Support

9:00 am to 5:30 pm Monday to Friday (Eastern Time)

Tel: [phone]

Fax:+ 416 674-8262

E-mail: [e-mail]

Internet: www.lavalink.com

Lava Computer MFG Inc.

This device complies with part 15 of the FCC Rules. Operation is subject

to the following conditions: (1)This device may not cause harmful interference,

and (2) this device must accept any interference received,including interference

Lava Computer MFG Inc.908 Niagara Falls Blvd. #629.North Tonawanda NY 14120-2060

that may cause undesired operation.