Instruction Manual
Mini Pendant Lighting
Wiring Instruction
1. Insert the green grounding screw into the hole with two raised
dimples on the mounting bar. Wrap the ground wire from the fixture
(if supplied) around the green grounding screw, then connect it to
ground wire from the outlet box (if not fixed on the outlet box) using a
wire connector(not supplied). If ground wire from the fixture is not
supplied, wrap the ground wire (if not fixed on the outlet box) from the
outlet box around the green grounding screw and tighten it.
NEVER CONNECT GROUND WIRE TO BLACK OR WHITE POWER
SUPPLY WIRES.
2.Take note of the color of the wire(s) on your fixture. Identify which
group your fixture wire(s) falls into and connect the wires according
to the directions below:
Overview
Outlet box
Black
Wire nuts
Smooth
Green(Ground)
Bare copper wire(Ground)
White
Ribbed
J.Mounting strap
I.Screw
H.Screw
G.Canopy
F.Knob
E.Stem
D.Stem
C.Stem
B.Stem
GROUP A:
Connect to Black House Wire
BLACK WHITE
*PARALLEL WIRE (round & smooth) *PARALLEL WIRE (square & ridged)
WHITE OR GREY WITH TRACER WHITE OR GREY WITHOUT TRACER
BROWN, GOLD OR BLACK
WITHOUT TRACER
GROUP B:
Connect to White House Wire
BROWN, GOLD OR BLACK
WITH TRACER
3.Take your fixture wire(s) from group A and place evenly against the
black wire from the outlet box. Do NOT twist wires together before
using wire connectors.
4.Fit a wire connector over the wires and screw the connector
clockwise until you feel firmness.
5.Try gently to pull the connector off the wires. If you can pull the
connector off, carefully re-do steps 3 and 4 as above, and check again
for a firm connection.
6. Connect the fixture wire from group B to the white wire from the
outlet box in the same manner. Make sure no bare wires can be seen
outside wire connectors.
Product Specifications
Input voltage 120V
Rated power 60W MAX
Lamp socket E26
Cord Length 6ft.
A.Lamp fixture
K.Siderosphere
L.Screw
M.Bulb(not included)
Assembly Instruction
1.Install Siderosphere K on Lamp fixture A and fix it with
Screw L.
2.Screw Stem B C D E to Lamp fixture A one by one.
3.Screw Canopy G to Stem E.
4.Connect the wires according to the picture above.
(Please refer to the wiring instruction for details )
5.Fix Mounting Strap J to the outlet box with Screw H.
6.Pass Canopy G through the Screw I and fix it with Knob F.
7.Install Bulb M(not included) into socket.
Product Packaging
Lamp fixture × 1
Stem× 4
Canopy × 1
Screw × 2 & Wire nut × 3
Siderosphere × 1 & Screw × 4
Lamp instruction × 1
Cleaning
To clean, wipe fixture with a soft cloth. Clean glass with a mild soap.
Do not use abrasive materials such as scouring pads or powders, steel
wool or abrasive paper.
Safety Information
Always switch off the electricity supply and allow to cool for 10 minutes
before changing the light bulbs.
Loading...