ASSEMBLY INSTRUCTIONS
BEFORE YOU START:
1. Place the Chair Back facing upward on a soft and flat
surface . Attach chair seat to the chair back, using Flat
Washer (E), Lock Washer (D), Bolt (A) for center the
insert and Bolts (B) for in the corners. Tighten with
Wrench (F). (See Figure 1 & 2)
2. Attach the front leg to the front corner block of the
chair seat, using Flat Washer (E), Lock Washer (D), Nuts
(C) and tighten all nuts with Wrench (G). (See Figure 3)
3. Repeat the process for the other front leg.
4. Tighten all bolts and nuts before use.
INSTRUCTIONS:
TOOLS REQUIRED:
D
C
B
A
No.
Q'ty
Hardware List
Hex Nut Ø5/16"
Lock Washer Ø5/16"
Flat Washer Ø5/16"
Spanner Wrench 12mm
Bolt Ø5/16"x1-1/2"
Allen Wrench 5mm
E
F
G
Bolt Ø5/16"x3-1/2"
Allen Wrench (supplied, part # F)
Spanner Wrench (supplied, part # G)
E
D
A
F
Figure 1
D
E
B
F
Figure 2
G
E
D
C
Figure 3
Chair Back
Chair seat
Front leg
1. Check the parts against the parts list to make
sure all items are present.
2. Assemble your furniture on a soft, flat surface to
avoid scratching the finish.
3. CAUTION: Do not over tighten screws, nuts or
bolts during assembly.
4. Your furniture may require occasional tightening.
Thank you for purchasing furniture
Loading...