ASSEMBLING & INSTALLATION INSTRUCTIONS PRODUCT
For Wall Mount Fixture
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
MOUNTING THE FIXTURE
Installation (see fig.1)
1. Disconnect power at main electrical panel before
installation.
2. Drill two holes in the wall, distance and the same
distance from the keyhole of mounting plate. Attach the
mounting plate to the wall, aligning the plastic anchors
and junction box, lock it securely with the two wood
screws and the two box screws. The side of the
mounting plate marked “GND” must face out. The
junction box is not included.
3. Guide fixture wires through hole in center of mounting
plate.
4. Follow wiring instructions carefully (see fig.2)
5. Place the backplane(B) over the mounting plate，aligning
the backplane holes with screw hole of the mounting
plate, then lock it securely with ball nut(C).
6. Install the light bulbs in accordance with the fixture’s
specifications. NOTE: DO NOT EXCEED THE
MAXIMUM WATTAGE RATING!
7. Attach the glass shade(A) inset the cover of lamp holder,
by turning it clockwise until tight.
Wiring (see fig.2)
1. Connect the electrical wires as follows. Connect the
Black wire from the fixture to the black house (hot)
Wire. Connect the white wire from the fixture to the white
(neutral) house wire. Make sure all wire nuts are secured.
You may wrap the connections with electrical tape. If
your outlet box has a ground wire (green or bare copper)
connect fixture’s ground wire to it. Otherwise attach the
bare copper fixture wire to the green ground screw on the
mounting plate.
2.Tuck the wire connections neatly into the wall junction
box.
Fig.1
Fig.2
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green or
Bare Copper(Ground)
Loading...