Assembly Instructions
Caution: You must read this before you proceed
Table
Caution: This Table is NOT a TOY
Keep your child/children at bay during the assembly process.
Whenever moving/lifting the Table and to prevent damage to the Table, two
adults are needed to execute these actions.
1 of 5
Label Picture Description QTY
A Table Top 1
B Leg 4
Label Picture Description QTY
①
Bolt
(M8x50mm)
9
②
Washer
(M8.5/20x2mm)
9
③
Spring Washer
(M8.5/14x2mm)
9
④ Allen Key 1
Hardware
Assembly Preparation
Part List
Before Beginning Assembly:
2 of 5
Step 1
This Table has multiple parts and may require up to 30 minutes to assemble. To give you
an overview of the Table parts, the above picture is to help you put the various parts into
perspective. Please read through the instructions below to familiarise yourself with the
parts and steps before assembly.
Unpack and place all parts on a clean, non-marring surface.
Overview
Assembly Steps
FRONT FACING
Table Top
(A)
Leg (B)
3 of 5
Step 2
Step 3
Place the Table Top(A) facedown onto a clean, non-marring surface.
Attach Leg(B) into the mounting position at the corner of the Table Top(A) using
Bolts(①), Washers(②), and Spring Washers(③) with Allen Key(④) as shown above.
Repeat the same process with the remaining three Legs(B).
Do not fully tighten the Bolts.
Stand the Table up, with assistance from your adult partner.
Exert pressure floorwards, onto the Table with both your hands.
This pressure will help the Legs and Table Top reach full alignment status.
Check for wobbles on a LEVEL surface.
If no wobbles are found proceed to tighten the Bolts in a sequential manner, until evenly
secured.
When tightening the Bolts tighten sequentially.
Do not tighten any Bolt fully and then move on towards the next one.
If there are still wobbles, loosen the Bolts and excute the same above process.
If the Table is not Stable it could lead to damage to the product.
Your Table is ready for use.
This Table can only be used on a flat, level surface.
4 of 5
5 of 5
Loading...