ASSEMBLY INSTRUCTIONS
LOOP AUT
CANOPY
NIPPLE
HEX NUT
CIRCULAR STRAP
WIRE CONNECTOR
POWER SUPPLY WIRE
GROUND GREEN SCREW
MOUNTING SCREW
TOP LOOP
CHAIN
OUTLET BOX
GROUND WIRE
FIXTURE LOOP
CHAIN LINK
LED MODULE
STEEL PANEL
DECORATIVE KNOB(1)
GLASS(2)
SCREW(4)
SCREW(3)
READ & SAVE
INSTALLATION & OPERATION INSTRUCTIONS
TOOLS & MATERIALS REQUIRED
CAUTION
Prior to assembly, refer to ELECTRICAL CONNECTIONS section. If you do not have electrical
wiring experience, refer to a do-it-yourself wiring handbook or have your fixture installed by a
qualified licensed electrician.
GENERAL
1. Be sure to read these instructions and review the diagrams thoroughly before beginning.
2. Electrical connections must be in accordance with local codes, ordinances, or the National
Screwdriver Wire Cutters
Adjustable Wrench Wiring Supplies
Electric Code. If you are unfamiliar with methods of installing electrical wiring, secure the
services of a qualified licensed electrician.
3. Before starting the installation, disconnect the power by turning off the circuit
breaker or by removing appropriate fuse at fuse box. Turning the power off at the light switch is
not sufficient to prevent electrical shock.
PREPARE THE FIXTURE
NOTE: First turn off electricity
1. Thread nipple into loop until snug. Thread the other end of nipple into the crossbar strap
until snug and secure with the lock washer and hex nut. Note the length of nipple into circular
strap may be adjusted if necessary.
2. Attach the crossbar strap assembly to the ceiling outlet box with screws, the side of the
strap marked "GND" must face out. Tighten screws securely with screwdriver. Determine the
desired hanging height and remove the excess chain with proper chain pliers to avoid
damaging the finish.
3. Open one end of the chain and connect it to the fixture chain loop and close the link. Thread
the wire carefully through the chain links. Place threaded ring followed by canopy over the
chain and allow them to carefully rest on the fixture body. Open the other end of the chain and
attach it to chain loop and close the link. Feed the wires through loop, and nipple.
4. Connect the electrical wires, making sure that all wire connectors are secured. If your outlet
has a ground wire (green or bare copper), connect the fixture’s ground wire to it. Otherwise,
connect the fixture’s ground wire directly to the crossbar using the green screw provided.
ELECTRICAL CONNECTIONS 120V~, 60Hz
Connect white wire(s) from fixture to white neutral wire from supply circuit.
Connect black wire(s) to black hot wire from supply circuit. Connect green wire to green or
bare wire or grounding screw on mounting bracket. In all cases grounding conductor to earth
must be used. Use UL/CSA Listed wire connects suitable for the size, type, and number of
conductors. No loose strands or loose wires should be present. Secure wire connectors with
UL/CSA Listed electrical tape.
Tuck the wire connections neatly into the junction box.
5. Raise the canopy to the ceiling and secure with threaded ring.
6. Installation is complete. Turn on the power at the circuit breaker or fuse box. Turn the light
switch on to activate the fixture.
7. LED replacement. Take down the decorative knob(1) and glass(2), unscrew the
screws(3), take down heatsink, unscrew the LED screws(4) then pull out LED module,
finally replace LED module by quick connector, secure the screws.
CAUTION: LED fixtures can operate at high temperatures please
use caution when touching during operation or after operation.
Loading...