Assembly Instructions
needed to execute these actions.
Caution: You must read this before you proceed
Table
Caution: This Table is NOT a TOY
Keep your child/ children at bay during the assembly process.
For moving the Table and to prevent damage to the Table, two adults may be
Page 1 of 6
Label Picture Description QTY
Panel
①
②
Parts List
A Table Top 1
B
C
First Leg Panel
(Labelled B)
Second Leg
(Labelled C)
1
1
Hardware
Label Picture Description QTY
Screws
(M6x45mm)
Allen Key 1
9
Assembly Preparation
Before Beginning Assembly:
Page 2 of 6
Assembly Steps
Page 3 of 6
Overview
First Leg Panel
(B)
Table Top (A)
Second Leg
Panel (C)
FRONT FACING
This Table has multiple parts and may require up to 30 minutes to assemble. To give you
an overview of the Table parts, the above picture is to help you put the various parts into
perspective. Please read through the instructions below to familiarise yourself with the
parts and steps before assembly.
Step 1
Unpack and place all parts on a clean non -marring surface.
Step 2
Position seperated point of the Second Leg Panel (C) over the First Leg Panel (B) on
to the Table Top(A).
②)
Place the Table Top ( A) facedown on a clean, non-maring suface.
Position the First Leg Panel (B) on to the Table Top(A).
B
A
A
C
B
Page 4 of 6
2
1
Insert three Screw (①),through the mounting positions of the First Leg Panel ( B) and affix
using the Allen Key(②)
Only loosely tighten the Screws.
Step 3
Step 3.1
3.1)
2
Step 3.3
1
2
1
Step 3.2
3.2) Insert four Screws (①)through the mounting positions of the Second Leg Panel (C)
into the Table Top(A) and affix using the Allen Key(②)
3.3) Affix First Leg Panel (B) and Second Leg Panel (C) using Screw (①) with Allen
Key(
Only loosely tighten the Screws.
Inspect Table and make sure all parts are adequately connected.
Step 4
If wobble
Page 5 of 6
Test again
30cm-50cm
Place the Table right side up on a LEVEL SURFACE to see if it wobbles.
If it wobbles,lift the Table to some 30cm to 50cm height from the ground.
Keep your feet and tose weell away from the drop zone.
Drop the Table freely and vertically with the four legs,hitting the ground,at the same
time.This Drop Test will help to ensure that all the Screws and gaps all reach full alignment
status.
Test again for evenness on a LEVEL SURFACE .
If no wobbles are found, proceed to tighten all Screw.
CAUTION: When tightening the Screw tighten sequentiall.DO NOT tighten any Screw
fully and then move towards the next one. This could cause the frame to warp.
If there are still wobbles ,loosen the Screws and execute this same drop test.
If the Table is not stable, it could lead to damage to the product.
Step 5
Your Table is ready for use
This Table can only be use on a flat, level surface.
Page 6 of 6
Loading...