SWING ARM FLOOR LAMP
ASSEMBLY INSTRUCTIONS
Note: The electrical wire is connected continuously through the
body arm. Do not pull wires during unpacking, bad connections
may result.
E
F
G
1) Connect the lamp body(
wrench(
2) Clasp spring(
the card slot(
clasp spring into(
slot(
3) Place the lamp shade(
lamp holder outer ring(
4) Install the light bulb(
*use 100W incandescent light bulb maximum
(23W CFL equivalent)
5) Use handles(
D) to tight screw(C) into lock in place.
J) into the card slot(K) then pull the spring into
L) with enough force(2pcs). As the same time,
M) card slot then pull the spring into the card
N) with enough force(2pcs).
E) to adjust the lamp height.
B) to the base(A), and use hex
H) into lamp holder(F), and tighten by
G)
I) (not included) within the lamp holder.
WARNING:
The lamp produces very high temperature. Always unplug
electrical wire and allow sufficient time for bulb to cool down
before replacing bulb.
M
N
H
J
(NOT INCLUDED)
I
E
C
D
L
B
A
E
K
A B C D G H J
4PCS
Loading...