Latchways LadderLatch, TowerLatch SP, TowerLatch, Climblatch User Manual

MSA Latchways

®

Vertical Device

LadderLatch, TowerLatch, TowerLatch SP and Climblatch

1

Latchways, an MSA Company.

Vertical fall arrest device to

EN 353-1:2002 & CNB/P/11.073 and EN 353-1:2014 /prA1:2017.

Important

Carefully read all of the safety and user instructions before using this product; paying particular attention to all
sections of these user instructions that carry warning symbols and notices.

Warning symbol. This symbol is used throughout the instructions whenever there is a risk of
personal injury or death to either the installer or end user of the product. Ensure that these warnings
are read and understood and followed at all times.

Caution symbol. This symbol is used throughout the instructions whenever there is a risk of
damaging the Latchways product. Ensure that these cautions are read and understood and followed
at all times.

Mandatory symbol. This symbol is used throughout the instructions whenever there is a specific
instruction for Latchways product. Ensure that these important instructions are read and understood
and followed at all times.

Document number

Issue number

Change request

Date of issue

Verti_96

9

100123

13/1/2017

Verti_96

10

100223

07/07/2017

Part number / identification of device type

MSA Latchways

®

Vertical Device

LadderLatch, TowerLatch, TowerLatch SP and Climblatch

2

Latchways, an MSA Company.

IDENTIFICATION OF DEVICE TYPE

(Part number is to be found on the device label)

Part number

Device type

35429-00

TowerLatch SP Device (see section 1.7)

3100L-00T

LadderLatch Device

3100L-00AC

LadderLatch AC Device

3102L-00

TowerLatch Device

3102L-00AC

TowerLatch AC Device

3103L-00

LadderLatch Device (Canada)

3104L-00

LadderLatch Device (USA)

3105L-00

TowerLatch Device (USA)

Webbing strop

Additional cover

LadderLatch

TowerLatch

AC Type Devices

MSA Latchways

®

Vertical Device

LadderLatch, TowerLatch, TowerLatch SP and Climblatch

3

Latchways, an MSA Company.

Contents

1. Safety instructions.

2. Product specification.

3. Required equipment.

4. Requirements for use.

5. Before use checks.

6. User instructions.

7. Materials.

8. Disposal

9. Inspection, maintenance and storage.

10. Markings.

11. Product Card.

12. EC Declaration of Conformity.

13. Appendix 1 - ClimbLatch

Installer company details

Company Name

Company Address
Contact Name

Tel No
Email

MSA Latchways

®

Vertical Device

LadderLatch, TowerLatch, TowerLatch SP and Climblatch

4

Latchways, an MSA Company.

Shock pack label

Date of manufacture

1. Safety instructions

When using the Latchways vertical device, basic on site safety precautions, including the
following, should be observed to ensure personal safety.

All Users of the Latchways vertical devices shall be trained and competent in its safe use and shall read and
follow these instructions. Retain these instructions for future reference.

 Never allow more than one person to attach to the Latchways vertical device at any time.
 Before use always visually check and inspect the system for any faults, ensuring it is secure and has a valid

test certificate.

 Always use a full body harness complying with national standards. Waist belts are not suitable for use with

this device.

 Before use ensure the karabiner attaching the Latchways vertical device to the harness is in the closed and

locked position.

 Do not use the Latchways vertical device for work positioning (i.e. primary means of support); to support

either partial or full body weight.

3100L, 3102L, 3103L, 3104L & 3105L type devices Maximum Rated Load (for systems incorporating a single
6 kN coil energy absorber) – The system can be used by a maximum of 3 Users. The total maximum rated load
for the system shall not exceed 400 kg (880 lbs) (total User weight including tools and equipment carried). The
maximum rated load for a single device shall not exceed 150 kg (330 lbs) (single User weight including tools
and equipment carried).

35429-00 TowerLatch SP device Maximum Rated Load – The maximum weight of any User (including tools
and equipment carried) should not exceed 100kg (220 lbs) unless the following label is visible on the energy
absorber indicating 150Kg (330 lbs) User weight is permissible.

Warning!

Only TowerLatch sp devices with a label indicating the maximum User weight are suitable for
users up to 150kg (330 lbs) all other devices that do not have a label indicating the maximum
User weight are only suitable for users up to 100kg (220 lbs).

MSA Latchways

®

Vertical Device

LadderLatch, TowerLatch, TowerLatch SP and Climblatch

5

Latchways, an MSA Company.

The minimum mass of User on any device including tools and equipment must not be less than 50 kg

The required minimum distance below the User’s feet and the ground is 2 m (6’6”). Below 2 m (6’6”) the
user may not be protected against hitting the ground or obstacles below. Therefore, extra care must be
taken when ascending / descending the first 2 m (6’6”).

Temporarily disabling or manually handling the lock/release mechanism of the device during ascent or
descent may hinder the safe operation and diminish the effect of the braking mechanism.

Before and during operation of the vertical fall arrest system consideration should be given as to how any
rescue could be safely and efficiently carried out.

The Latchways devices have been subjected to an additional series of tests devised by TUV/NEL (Notified
Body no. 0320). These tests were conducted using 71 kg (156 lbs) and 100 kg (220 lbs) anthropomorphic
test dummies with different body postures (reference NEL certificate no. MTHH).

MSA Latchways

®

Vertical Device

LadderLatch, TowerLatch, TowerLatch SP and Climblatch

6

Latchways, an MSA Company.

The following medical conditions could affect the safety of the User:

heart disease / chest pain.
high blood pressure.
epilepsy, fits, blackouts.
fear of heights / vertigo.
giddiness / difficulty with balance.
impaired limb function.
alcohol or drug dependence.
psychiatric illness.
diabetes.

Do not modify or alter the Latchways device without prior consent in writing from Latchways
plc.

The Latchways device is not to be used for any other use than providing attachment for one
User to a Latchways cable system. During use do not allow any clothing, equipment,
appendages or any other items to restrict the operation of the device.

If the Latchways is resold for use outside the original country of destination the reseller shall
provide instructions for use, maintenance and periodic examinations in the language of the
country of destination.

The device is only to be used to provide an attachment for one User to a Latchways vertical
cable system. All system components shall be manufactured and specified by Latchways
plc. The cable shall be Ø8 MM (5/16”) 1 X 19 construction grade 316 stainless steel to
BS.MA 29 or AISI 316

Do not use the device at temperatures below -30 °c.