LA STEELCRAFT EC20IH User Manual

Single sheave truck, cast aluminum revolving, non-fouling, internal halyard truck
1/8" x 7x19 Mil-C-5424 Stainless steel aircraft cable
Model EC20 IH
Standard flag arrangement: 3' x 5'
Neoprene coated 2" diameter steel counterweight
Nylon beaded retainer ring
Gearless, self locking direct drive winch with six tumbler cylinder lock
8"
Tapered portion: 11'-0"
Exposed height: 20'-0"
Revolving non-fouling internal halyard truck, cast aluminum body, 26 stainless steel ball bearings, and 2-1/2" diameter plated steel sheave.
7"
Aluminum flash collar
3000 PSI concrete
Hardwood wedges (supplied by others)
Dry sand tightly tamped after aligning pole
Foundation sleeve -16 ga hot dip galvanized steel
Steel centering wedges
1/4" Steel base plate
1/4" Steel support plate welded to grounding spike
Project: Location: Architect: Contractor Customer:
Overall length: 23'-0"
Access door : 4' - 0"
3'-0"
Straight portion: 12'-0"
Foundation: 3'-6"
6"
6"
12"
12"
24"
Ground set tapered aluminum flagpole: ALLOY: 6063T6 Exposed height: 20'-0" Ship in 1
Top diameter: 3"
Finish: 100
section
grit polish
Overall height: 23'-0" Butt diameter: 5" Wall thickness: .188"
Winch Detail
All shafts with overall length of more than 38'-6" are shipped in two sections.
Each section matched marked for field assembly. Exposed portion of jam sleeve must be well lubricated prior to assembly.
1-1/2" maximum shop gap allowed for field fitting (ram for tight joint)
Date: Revision:
Job: