LA STEELCRAFT 1444T User Manual
STEELCRAFT PRODUCTS
P.O. Box 90365 - Pasadena, CA 91109
PHN 626-798-7401 FAX 626-798-1482
DO NOT SCALE DRAWING
21'-6"
14'
MODEL
1444T
BASEBALL BACKSTOP
FINISHED
GRADE
7'-1"
3'-0" (TYP.)
24" DIA. X 60" DEEP
CONC. FOOTING (TYP)
(SUPPLIED BY OTHERS)
FRONT ELEVATION
30'-0"
44'-0"
PLAN VIEW
NOTE: SPECIFICATIONS ARE SUBJECT TO CHANGE
DO NOT SCALE DRAWING
DATE: 10/22/07
DRAWN BY: AFS
STEELCRAFT PRODUCTS
P.O. Box 90365 - Pasadena, CA 91109
BASEBALL BACKSTOP
MODEL
1444T
PHN 626-798-7401 FAX 626-798-1482
ASSEMBY INSTRUCTIONS
1. Dig six (6) holes @ 60" deep and 24" diam as show n on th e plan view.
2. Place the four 3-1/2" od back posts (A) in the four b a ck ho les.
3. Place the two 3-1/2" od end posts (B) in the en d holes with lugs parallel to the front opening.
4. Each post shall be 14'-0" above ground and 10'-0" on center. Place a horizontal brace (C)
on the ground between ea ch of the p os ts. Place a rail end fitting on each end of these
braces. Place a brace band over ea ch po st a d jacent to ea ch rail end fitting. Bolt rail
end fitting to the corresponding brace band. Make sure the horizontal brace fits into the rail
end fittings at least 1". If they don't, adjust the posts accordingly.
**NOTE: All carriage bolt heads are facing the playing field.
5. With the proper spacing assured, plumb all posts and pour the concrete footings. Allow
24 hrs. for concrete to set and then proceed as follows.
6. Attach four angle fittings (H) to back posts (A) .
7. Hood Post Erection: Insert the four hood support posts (D) into open end of the four angle
fittings (H) on back posts, with bent portion toward the playing field.
8. Tighten set screws holding hood posts in place.
9. Install mid (C) and front ( E) hor izontal tie members, using four "T" fitting (i). Attach
triangle su pports (F).
10. Install horizontal braces ( C ) b etw een th e po st s a b ove gr ou nd . These braces can be
installed in a manner s im ilar to directions in item 4. Larger size b ands are f urnis hed for use on t he
angle fittings.
11. Unroll the 9 ga wire (J) from end of roll. Stretch the wire for measuring and open the
knuckle on each side of the roll at 9'-7" and weave out one strand of wire.
12. Weave a tension bar (T) through the last loops on the un-knuckled sides. Place this wire
against playing field side of one of the wing panels with the tension bars parallel to the
uprights.
13. Stretch wire on the wing panels. Slip 6 tension bands (N) over each post adjacent to the
tens io n bars. The tension bars must be off set so that the wire will b e str e tched on th e
playing field side (inside) of the backstop. Equally space the 6 tension band up and down
the posts on each side of the wire panel and bolt into position.
**NOTE: If the wire is too loose, remove a strand of wire as in item 11 above or,
if the wire is too tight to fasten into position, reweave into panel, the strand of
wire removed in item 11 above.
14. S tretc h Wire B ack Panel Th e back t wo pa nels will be stretch ed in o ne piece between
outside back posts (A). The length of the wire needed sh ou ld be 3" shorter than the
distance between the inside of the two corner posts (A) . (Make sure wire is stretched when
measuring)
15. Place this wire against the playing field side of the backstop with the tension bars
parallel and adjacent to posts (A ). Stretch and secure into position with 6 tension bands
on each post.
16. Install and stretch wire in the opposite wing as described in items 12 and 13 above.
17. Stretch Wire - Hood Panels Install wire on hood, one panel at a time. Measure out the
11 ga c hain lin k (J) wire as in it e m 1 2 above. a nd ins tall as in item 13 .
**NOTE: Wire goes on the outside (top) of hood.
18. S tretc h Wire - Corner Pane ls Install w ire on c orner panels using 11 ga chain link (K) wir e .
Cut off extra wire where necessary. Tie at 12" along top side panels.
19. Use tie wire (O) and tie all chain link to the adjacent horizontal braces at approx. 18" apart.
20. Tighten all set screws and bolts & nuts.
DO NOT SCALE DRAWING
DATE: 10/22/07
DRAWN BY: AFS
Loading...