Lassco Wizer LASSCOJOG LJ-8 User Manual

Page 1
Before operating this equipment, please read these instructions completely and keep these operating instructions for future reference.
485 Hague Street, Rochester, NY 14606 U.S.A. Tel: 585-436-1934 Fax: 585-464-8665 www.lasscowizer.com info@lasscowizer.com
Serial Number: Date of Purchase: Dealer: Address:
Telephone Number:
Page 2
Instructions
Setting Up Your Machine
Your LJ-8 LasscoJog Paper Jogger comes ready to use. Simply plug in the power cord and turn on the machine.
Adjusting the Jogging Speed
To change the Jogging action, access the adjustment discs on the underside of the machine as
To change the Jogging action, access the adjustment discs on the underside of the machine as shown. Loosen Button Head Machine Screw and rotate one of the Adjustment Discs
shown. Loosen Button Head Machine Screw and rotate one of the Adjustment Discs attached to the Disc Shaft extending from the Motor . Tighten down the Machine Screw.
attached to the Disc Shaft extending from the Motor . Tighten down the Machine Screw.
Note:
Side View
L-1014: Motor
FM5-5008: Electric Cord
L-1020: #6 Hose Clamp
L-1019: Torque Tube
L-1021: Shaft Collar
L-1017: Eccentric Adjustment Disc
10-32 Screw x 3/4 Button Head Machine Screw
L-1018: Eccentric Disc Shaft
3/8” ID x 3/4” OD Fiber Washer
L-1016: Clevis
L-1034: Flange Bearing
Underside View
When the screws are located opposite each other on the shaft, the minimum action is obtained. When the screws are located on the same side of the shaft, the maximum action is obtained. Normal action is obtained when the screws are 80 to 90 apart.
Page 01
Page 3
Trouble Shooting Guide
Problem Cause Correction
Machine does not turn on. Machine is not plugged in or
there is no electricity to the outlet.
Power switch is faulty.
Motor has burned out.
The motor turns on but the machine does not jog as desired.
The Torque Tube (L-1019) has worn out or broken.
The screw on the Eccentric Adjustment Disc (L-1017) has come loose allowing the disc to shift.
Make sure the power cord is connected correctly and that the outlet is live.
Contact a service technician to replace the power switch.
Contact a service technician to replace the motor.
Replace the Torque Tube.
Access the Adjustment Discs and tighten down the screw as shown on page 1.
Page 02
Loading...