LaserLyte UTA-FR User Manual

Auto-Off Feature:

• After 5 minutes in any mode, warning mode pulse will activate.

• After 1 minute in warning pulse mode, laser will turn off.

• Press the switch during warning pulse for laser reset.

L

ASER

L

YTE

L

ASER

L

YTE

5 min.

L

ASER

L

Batteries: 3 x 392 batteries

• Batteries can be changed with laser installed on gun!

• Remove battery cover

• Insert 3 x 392 batteries (+ side up).

• Tighten down the battery cover, and check periodically.

L

ASER

L

YTE

L

ASER

L

YTE

®

5 min.

YTE

6 min.

Off

• Fits SCCY Pistols:

- CPX-1

- CPX-2

• Ergonomic activation

• Dual Modes: pulse and constant on

• Auto-Off feature

UTA-FR

• Quick and Easy Installation

WARRANTY:

Three Year Limited

Warranty.

DANGER

LASER LIGHT AVOID DIRECT EYE EXPOSURE

POWER OUTPUT < 5mw WAVELENGTH 630-670mm

CLASS IIIa PRODUCT

®

30 N. Alamos Drive - Cottonwood, AZ 86326

Phone [phone] - Fax [phone]

www.LaserLyte.com

REV614

®

SCCY Firearms Gen 2 Pistols CPX-1 & CPX-2

J3

C1

J1

U1

S1

Activation:

L

ASER

L

YTE

L

ASER

L

YTE

L

ASER

L

YTE

L

ASER

L

YTE

L

ASER

L

YTE

L

ASER

L

YTE

L

ASER

L

YTE

RIGHT SIDE LEFT SIDE

* Read instructions completely before installing your laser.
Failure to do so may result in damage to your laser or firearm.

Installation:

•

UNLOAD FIREARM.

•

Attach danger label to side of gun near laser with arrow pointing

toward front sight

1

Place right-side of laser body on gun, ensuring proper placement.
Place small button provided into button hole in left-side of laser body.

2

3

Lower right side of laser and gun onto the left side of laser, rocking the
two sides into place.

ENSURE PROPER BUTTON PLACEMENT.

4

5

SQUEEZE BOTH SIDES TOGETHER. While squeezing together, from the left
(non battery cover) side insert one of the provided 1/2" hex head screws.
Tighten the 1st screw until it catches, then repeat with the other screw.
Alternate, tightening both screws down until the gap between both sides of
the laser is closed.

UTA-FR

Installation: •

UNLOAD FIREARM

1 2

J1

U1

S1

J3

C1

3

4

YTE

L

ASER

L

This laser has ambidextrous activation.

1

L

ASER

L

YTE

Press once turns laser on: constant or pulse

2

Press and hold for 5 seconds to change mode.
Second press turns laser off.

3

ON/OFF

1 2 3

ON/OFF

or

5 sec.

ON/OFF

ON/OFF

or

ON/OFF

Laser Sight In:

1

Use the provided .035 hex key to adjust the sight.

2

Always end adjustments on a clockwise turn.

3

5

YTE

L

ASER

L

Make final adjustments at shooting range.

1 3

2

Windage

Screw

Windage

right

left

Elevation

down

up

Moving

Laser

Dot