LaserLyte RL-TOOL User Manual
RL-TOOL
Instructions
Installing Rear Sight Laser:
1
Unload your firearm.
2
Remove slide from frame, then remove spring & barrel.
3
Insert the rear sight laser on your slide. Align side of dovetail
with sight tool.
4
Use the adjustable clamp screws to hold the slide at the
proper height.
5
Turn the T-handle clamp until the extractor pushes the rear
sight laser into the center of the slide.
1
UNLOAD YOUR FIREARM!
2
3
5
YES
YES
4
4
NO
NO
Removing Factory sights:
1
Unload your firearm.
2
Remove slide from frame, then remove spring & barrel.
3
Use the adjustable clamp screws to hold the slide at the
proper height. Remove sight with extractor moving left to right.
a) For straight dove tails including
4
See Figure 4a
b) For lead in dove tails including
S&W® and M&P®
See Figure 4b
5
Turn the T-handle clamp until the extractor pushes the rear
sight off of the slide.
1
UNLOAD YOUR FIREARM!
2
4
a) Straight Dove tail
Glock® and Springfield XD®
Ruger SR9®, 1911 Novak®,
3
b) Lead In Dove tail
5
Care & maintenance of the RL tool:
1
Oil both ends of shaft prior to each use
1
WARRANTY: ONE YEAR LIMITED WARRANTY
DANGER
LASER LIGHT
AVOID DIRECT EYE EXPOSURE
POWER OUTPUT < 5mw
WAVELENGTH 630-670mm
CLASS IIIa PRODUCT
A Division of P&L Industries
101 Airpark Road - Cottonwood, AZ 86326
Phone 928-649-3201 - Fax 928-649-3970
5
®
www.LaserLyte.com
Loading...