![](/html/04/0422/04227dc48738f9c9b65858b4da97e249f0963b91aab9abeb6f7e58f10db523e0/bg1.png)
Batteries: 4-377 batteries
DANGER
LASER LIGHT AVOID DIRECT EYE EXPOSURE
POWER OUTPUT < 5mw WAVELENGTH 630-670mm
CLASS IIIa PRODUCT
®
30 N. Alamos Drive - Cottonwood, AZ 86326
Phone 928-649-3201 - Fax 928-649-3970
www.LaserLyte.com
Tighten down battery cover, check periodically.
NAA-VM
®
• Fits North American Arms®
Black Widow and Mini Master
• Simple user friendly installation
• Pre-sighted in
• Dual laser modes with auto-o
• All aluminum construction
®
WARRANTY:
Three Year
Limited
Warranty.
DANGER
LASER LIGHT AVOID DIRECT EYE EXPOSURE
POWER OUTPUT < 5mw WAVELENGTH 630-670mm
CLASS IIIa PRODUCT
30 N. Alamos Drive - Cottonwood, AZ 86326
Phone 928-649-3201 - Fax 928-649-3970
www.LaserLyte.com
®
REV0712
®
![](/html/04/0422/04227dc48738f9c9b65858b4da97e249f0963b91aab9abeb6f7e58f10db523e0/bg2.png)
1
2
3
4
•
UNLOAD FIREARM.
•
Attach danger label to side of gun near laser with arrow pointing
toward front sight.
•
DO NOT TOUCH THESE SCREWS.
(Figure A)
To fit the Mini Master, remove
this screw and triangle block
Laser for North American Arms® Black Widow & Mini Master
NAA-VM
Activation:
1
Press once turns laser on: constant or pulse.
2
Press and hold for 5 seconds to change mode.
Second press turns laser off.
3
1
laser has ambidextrous activation.
2
3
* Read instructions completely before installing your laser.
Failure to do so may result in damage to your laser or firearm.
•
•
Attach danger label to side of gun near laser with arrow pointing
Installation:
UNLOAD FIREARM.
toward front sight.
•
DO NOT TOUCH THESE SCREWS (Figure A).
1
While pointing firearm in safe direction place cylinder back into
gun.
2
Turn laser block 90 degrees to cylinder pin and slide into cylinder
pin groove.
3
Once fully seated in cylinder pull down on laser body and turn
towards muzzle locking laser in place.
When properly installed laser should not turn to sides.
4
ON/OFF ON/OFF
5 SECOND HOLD TO CHANGE MODE
Auto-Off Feature:
• After 5 minutes in any mode, warning mode pulse will activate.
• After 1 minute in warning pulse mode, laser will turn off.
• Press the switch during warning pulse for laser reset.
5 min.
5 min.
6 min.
Off