LaserLyte MBS-PAK User Manual

MBS ACCESSORY KIT
DAYLIGHT LASER TARGET INSTRUCTIONS
1
REMOVE BORE TOOL FROM BARREL and sight in
your gun at 100 yards.
2
After shooting at the range put the target out 25
3
FIRST UNLOAD FIREARM
and then put bore tool
in barrel with the switch up.
4
Record position of laser dot when cross hairs are in
the center on Data sheet. (see reverse)
5
Store with target and check firearm when needed.
1
2
100 YARDS
3
UNLOAD FIREARM
SWITCH UP
Yrds.
DAYLIGHT LASER TARGET
25 YARDS
DAYLIGHT LASER TARGET DATA SHEET
4
Type of
Firearm
Type of
Ammunition
Elevation Windage
Laser Position
Daylight Laser Target
Simulated laser dot
DAYLIGHT LASER TARGET DATA SHEET
Type of
Type of
Ammunition
Laser Position
Elevation Windage
DAYLIGHT LASER TARGET
MBS ACCESSORY KIT
Gun Leveler
1
Slide gun leveler onto top scope rail.
2
Use the bubble level and adjust gun so bubble is between lines. Secure gun, mount scope and follow scope leveling directions.
1 2
Top View
Scope Leveler Adapter
1
UNLOAD FIREARM! Secure firearm in a rest and make level.
2
Follow 1-3 Sight-In Steps.
3
Put the adapter with ring over the end of the bore tool.
4
Adjust bubble between the two lines.
5
Turn on laser and shine on wall 3 yards/meters away.
6
Adjust cross hairs until they are parallel with red laser line.
7
Tighten down scope rings, pull off scope leveler and proceed to Sight-In steps.
1
3
5 6
3 Yards/Meters
2
4
Scope view
before
Center Bubble
Laser
line
Scope view
after
Shotgun Adapter
1
UNLOAD FIREARM! Insert bore tool into the shotgun adapter and thread into screw.
2
Put into shotgun barrel.
3
Hold shotgun adapter and twist the bore sighter until a snug fit. Once snug follow instructions for Sight-In steps.
4
1
2
WARRANTY:
Three year
limited warranty
DANGER
LASER LIGHT
AVOID DIRECT EYE EXPOSURE
POWER OUTPUT < 5mw
WAVELENGTH 630-670mm
CLASS IIIa PRODUCT
3
www.LaserLyte.com
®
Cottonwood, AZ 86326
20 Gauge
(.510 -.625 Caliber)
12 Gauge
(.625 -.750 Caliber)
30 N. Alamos Drive
Phone 928-649-3201
Fax 928-649-3970
Loading...