LaserLyte LT-PRO User Manual

®
Training with the LT-PRO will improve:
• Trigger Control
• Unsighted Fire / Point and Shoot
• Shooting from the Holster
• Precision Shooting
• Unorthodox Shooting Positions
WARRANTY:
Three Year
Limited Warranty.
DANGER
LASER LIGHT
AVOID DIRECT EYE EXPOSURE
POWER OUTPUT < 5mw
WAVELENGTH 630-670mm
CLASS IIIa PRODUCT
30 N. Alamos Dr. - Cottonwood, AZ 86326
www.LaserLyte.com
• Laser dot shines briefly when dry-firing
• Fits calibers .35 to .45 (.380 ACP, 9mm, .40S&W, .45 ACP, etc.) Minimum 2” barrel required
• Have fun with your dry-fire training
• Train anywhere and save ammo
LT-PRO
U.S. Patent No. 6,421,947
®
®
REV 0114
Laser Trainer Pro
Insert screw through plug & adapter and thread into taper of trainer.
LT-PRO Adapter Plug Screw Hex Key
LT-PRO
***With the LT-TTC, remove the "Plug" from the LT-PRO***
2
3
7
When not in use:
7
Insert into LT-PRO as shown.
THE SOUND ACTIVATED SWITCH IS ALWAYS LISTENING
THE BATTERIES ARE ALREADY INSTALLED. YOU MUST REMOVE THE
PLASTIC INSULATOR BEFORE OPERATION. SEE BATTERIES SECTION FOR INSTRUCTIONS.
Installation:
UNLOAD YOUR FIREARM!
1
2
Tighten or loosen screw for caliber fit.
3
4
Gently press the trainer into the muzzle of the pistol.
Ready your pistol and pull trigger to fire red laser dot.
5
(LaserLyte recommends the use of snap caps.)
When removing from your pistol, pull straight out!
6
Do not twist! Ensure all parts are out of barrel.
4
5
Correct removal
6
NO
NO
Batteries: (3) 377
1
Unscrew Battery cap Install new batteries.
Remove batteries. Tighten battery cap
2
Remove & discard insulator before initial use.
3
4
+ + +
Loading...