LaserLyte LT-C556 User Manual
®
• Large ambidextrous handle for
repeat shots
• Buffer tube block for safe and
short charging
• LT-223 laser fires laser dot to
simulate bullet impact
• 32 inch push rod for easy removal of
the laser cartridge
• Increased laser training saves time
and money
REV 1013
LT-C556
®
NEVER FIRE LIVE AMMO WITH TRAINING PARTS
NEVER FIRE LIVE AMMO WITH TRAINING PARTS
8
9
1
1
2
3
2
1
2
3
ACTIVATION:
Pull charging handle to reset firing pin.
Pull trigger.
Repeat.
Assemble the push rods.
Gently push out laser trainer.
Reverse the Installation steps for all other parts
.
REMOVAL:
DANGER
LASER LIGHT AVOID DIRECT EYE EXPOSURE
POWER OUTPUT < 5mw WAVELENGTH 630-670mm
CLASS IIIa PRODUCT
WARRANTY:
Three Year Limited
Warranty.
®
30 N. Alamos Drive - Cottonwood, AZ 86326
Phone 928-649-3201 - Fax 928-649-3970
www.LaserLyte.com
1
1 2 3
2
3
Unscrew the back of the laser located near the rim of the cartridge.
Take out old batteries and insert new batteries with positive (+) facing out.
Screw the cap back on all the way.
Batteries: (3) 377
7
Charging
Handle
LT-223 Laser Trainer
Buffer Block
AR TRAINING KIT
LT-C556
Push Rods
NEVER FIRE LIVE AMMO WITH TRAINING PARTS
INSTALLATION:
1
Unload Firearm. Follow all firearm safety guidlines.
2
Push out takedown pin. Separate upper and lower receivers.
3
Depress buffer retainer and remove buffer and spring.
4
Install LaserLyte buffer block and reinstall buffer and spring.
5
Remove bolt carrier group and charging handle.
6
Insert LT-223 into chamber.
7
Install LaserLyte red charging handle and original bolt carrier
group.
8
Reassemble upper and lower receivers. Push in takedown pin.
9
Use charging handle to reset firing pin.
10
Pull trigger and engage target.
1
2
43
4
NEVER FIRE LIVE AMMO WITH TRAINING PARTS
7
8
9
ACTIVATION:
1
Pull charging handle to reset firing pin.
2
Pull trigger.
3
Repeat.
NEVER FIRE LIVE AMMO WITH TRAINING PARTS
REMOVAL:
1
Assemble the push rods.
2
Gently push out laser trainer.
3
Reverse the Installation steps for all other parts
1
2
.
5
6
NEVER FIRE LIVE AMMO WITH TRAINING PARTS
Batteries: (3) 377
1
Unscrew the back of the laser located near the rim of the cartridge.
2
Take out old batteries and insert new batteries with positive (+) facing out.
3
Screw the cap back on all the way.
1 2 3
WARRANTY:
Three Year Limited
Warranty.
DANGER
LASER LIGHT AVOID DIRECT EYE EXPOSURE
POWER OUTPUT < 5mw WAVELENGTH 630-670mm
CLASS IIIa PRODUCT
30 N. Alamos Drive - Cottonwood, AZ 86326
Phone 928-649-3201 - Fax 928-649-3970
www.LaserLyte.com
®
Loading...