LaserLyte CK-SW User Manual
Uninstall:
Do the reverse of steps 1-8 on installation and remount on
1
another gun.
2
Loosen up both set screws until flush with laser body
3
Wait about 15 minutes for adjustment reset and then sight in.
Battery Installation: (4) 377
1
Open the cylinder.
Using provided wrench open battery cap.
2
Install new batteries.
3
4
Screw in battery cap and tighten.
1
Open the
cylinder
2 3
4
CK-SW
Patents Pending
WARRANTY:
One Year Limited
Warranty.
DANGER
LASER LIGHT AVOID DIRECT EYE EXPOSURE
POWER OUTPUT < 5mw WAVELENGTH 630-670mm
CLASS IIIa PRODUCT
®
A Division of P&L Industries
101 Airpark Road - Cottonwood, AZ 86326
Phone 928-649-3201 - Fax 928-649-3970
www.LaserLyte.com
Side Mount Laser Fits: S&W® J-Frame Revolvers
CK-SH
CK-SN
CK-SH
CK-SN
CK-SN
CK-SW
Installation:
Attach danger label to slide of gun near laser with
arrow pointing toward front sight.
1
Open the cylinder on your revolver and unload the gun.
Keep your cylinder open during installation.
2
3
Remove your grip on the revolver.
Remove the two side plate screws and store.
4
5
Align the plate holes with the screw holes on the revolver.
CK-SN: Fits model 637 and other exposed hammer frames
CK-SH:
6
If needed remount the laser on the correct plate and
Fits model 642 and other shrouded hammer frames
tighten screws.
Mount the plate to the side of the revolver using the provided
7
screws.
8
Tighten your screws down and replace grip.
Laser Sight In:
1
Open the cylinder
1
and unload the gun.
Keep cylinder open
2
during installation.
5
4
Use the provided .035 Allen wrench to adjust the sight.
2
Always end adjustments on a clockwise turn.
3
Make final adjustments at shooting range.
1 3
2
Windage
right
left
Elevation
up
down
Moving
Laser
Dot
Activation:
1
3
6
7
8
Press once turns laser on: constant or pulse.
2
Press and hold for 5 seconds to change mode.
Second: press turns laser off.
3
1
or
5 sec.
2
or
3
Auto-Off feature:
After 5 minutes in any mode, warning pulse will activate.
•
After 1 minute in warning pulse mode, laser will turn off.
•
Press the switch during warning pulse for laser reset.
•
5 min.
5 min.
6 min.
off
Loading...