LaserLyte CK-AMFZK User Manual
Auto-Off Feature:
• After 5 minutes in any mode, warning pulse will activate.
• After 1 minute in warning pulse mode, laser will turn off.
• Press the switch during warning pulse for laser reset.
L
ASERLYTE
L
ASERLYTE
5 min.
L
ASERLYTE
Batteries: 4-377 batteries
• Use Allen wrench .050 to remove battery cover.
• Polarity marked on board inside of battery compartment.
• Note: Dimples on battery cover must be face down.
• Tighten down the battery cover and check periodically.
Dimples Down
5 min.
6 min.
Off
CK-AMFZK
Patent Pending
®
• Fits Ruger® LCP, Kel-Tec® .380 ACP
& .32 ACP
• Quick and Easy installation
• Works with most pocket holsters
• Ergonomic activation
• Dual laser modes with auto-o
feature
® ®
WARRANTY:
One Year Limited
Warranty.
DANGER
LASER LIGHT AVOID DIRECT EYE EXPOSURE
POWER OUTPUT < 5mw WAVELENGTH 630-670mm
CLASS IIIa PRODUCT
®
30 N. Alamos Dr. - Cottonwood, AZ 86326
Phone 928-649-3201 - Fax 928-649-3970
www.LaserLyte.com
REV0512
®
®
L
ASER
L
YTE
ASERLYTE
Kel-Tec
Read instructions completely before installing your laser. Failure to do so may result in
damage to your laser or firearm.
/Ruger
®
.380 ACP Side Mount Laser
CK-AMFZK
L
ASERLYTE
Installation:
UNLOAD FIREARM.
Place on a raised surface.
Attach danger label to side of gun near laser with arrow
pointing toward front sight.
1
DO NOT REMOVE THIS PIN. (FIGURE A)
2
Using punch and small hammer remove Ruger® Frame
Pin #1. Insert LaserLyte
Tap out Pin #2 and replace with LaserLyte
3
Place laser on gun, align holes and insert screws.
4
(Kel-Tec
Use both .062 Allen wrenches to tighten screws until snug.
5
Do not over tighten! Tighten down the battery cover and
®
use frame adapter, then mount.)
check periodically.
The two LaserLyte
If you un-install the CK-AMFZK, re-apply a self-locking material such as Lock-tite
Threadlocker Blue 242® to the LaserLyte
®
frame pin screws are pre-loaded with a self-locking nylon patch.
®
Frame Insert Pin.
®
frame pin screws before re-installing the laser.
®
Insert Pin.
®
Unload firearm.
1 2
A
3
4
Kel-Tec® frame adapter
L
ASERLYTE
Attach danger label to slide of gun near
laser with arrow pointing toward front sight.
#1
#2#2
#2
5
#1
Activation:
1
Press once turns laser on: constant or pulse.
2
Press and hold for 5 seconds to change mode.
Second press turns laser off.
3
ON/OFF
1 2 3
L
ASERLYTE
or
L
ASERLYTE
5 sec.
L
ASERLYTE
or
L
ASERLYTE
Laser Sight In:
1
Use the provided .035 Allen wrench to adjust the sight.
2
Always end adjustments on a clockwise turn.
3
Make final adjustments at shooting range.
1 3
2
L
Windage
right
left
L
ASERLYTE
Elevation
up
down
L
ASERLYTE
Moving
Laser
Dot
Loading...