LaserLyte CK-AMF9ZK User Manual

Auto-Off Feature:

• After 5 minutes in any mode, warning mode pulse will activate.

• After 1 minute in warning pulse mode, laser will turn off.

• Press the switch during warning pulse for laser reset.

L

ASERLYTE

L

ASERLYTE

5 min.

Batteries: 4-377 batteries

• Use Allen wrench .050 to remove battery cover

• Polarity marked on board inside of battery compartment.

• Note: Dimples on battery cover must be face down.

• Tighten down the battery cover and check periodically.

Dimples Down

5 min.
6 min.

Off

CK-AMF9ZK

Patent Pending

®

• Fits Ruger® LC9 and Kel-Tec® PF9

• Quick and Easy installation

• Works with most pocket holsters

• Ergonomic activation

• Dual laser modes with auto-o feature

® ®

WARRANTY:

One Year Limited

Warranty.

DANGER

LASER LIGHT AVOID DIRECT EYE EXPOSURE

POWER OUTPUT < 5mw WAVELENGTH 630-670mm

CLASS IIIa PRODUCT

®

30 N. Alamos Drive - Cottonwood, AZ 86326
Phone [phone] - Fax [phone]

www.LaserLyte.com

REV0512

®

L

ASER

L

YTE

L

YTE

®

Kel-Tec

INTERNAL LOCK HOLE

Read instructions completely before installing your laser. Failure to do so may result in
damage to your laser or firearm.

/Ruger® 9mm Side Mount Laser

CK-AMF9ZK

L

ASERLYTE

Installation:

UNLOAD FIREARM.
Place on a raised surface.

Attach danger label to side of gun near laser with arrow

pointing toward front sight.

1

Using punch and small hammer, drift pin #1 out no more
than 1/4”. Immediately insert LaserLyte

®

mounting pin and
tap into place, completely replacing pin #1.
Follow the steps for pin #2 exactly as pin #1.

2

Place laser on gun, align holes and insert screws.

3

Do not block internal lock hole (N/A for Keltec

4

Use both .062 Allen wrenches to tighten screws until snug.

®

).

Do not over tighten! Tighten down the battery cover, and
check periodically.

The two LaserLyte
If you un-install the CK-AMF9ZK, re-apply a self-locking material such as Lock-tite
Threadlocker Blue 242® to the LaserLyte

®

frame pin screws are pre-loaded with a self-locking nylon patch.

®

frame pin screws before re-installing the laser.

Unload firearm.

1

Attach danger label to side of gun near laser with
arrow pointing toward front sight.

Activation:

1

Press once turns laser on: constant or pulse.

2

Press and hold for 5 seconds to change mode.
Second press turns laser off.

3

ON/OFF

#1

#1

1/4”

1 2 3

L

ASERLYTE

or

L

ASERLYTE

5 sec.

L

ASERLYTE

or

L

ASERLYTE

L

ASERLYTE

2

#2

INTERNAL LOCK HOLE

3

®

LASERLYTE

#2

Laser Sight In:

1

Use the provided .035 Allen wrench to adjust the sight.

2

Always end adjustments on a clockwise turn.

3

Make final adjustments at shooting range.

4

1 3

2

Windage

right

L

ASER

L

ASERLYTE

Elevation

up

down

left

Moving

Laser

Dot