LaserLyte ADP-ZK User Manual
Auto-Off Feature:
LASERLYTE
LASERLYTE
LASERLYTE
LASERLYTE
LASERLYTE
• After 5 minutes in any mode, warning mode pulse will activate.
• After 1 minute in warning pulse mode, laser will turn off.
• Press the switch during warning pulse for laser reset.
5 min.
Batteries: 3 x 392 batteries
• Batteries can be changed with laser installed on gun!
• Remove battery cover
• Insert 3 x 392 batteries (+ side up).
• Tighten down the battery cover, and check periodically.
5 min.
6 min.
Off
REV813
UTA-TA
®
• Fits Taurus Pistols:
- 738 TCP and
- 709/740 SLIM
• Ergonomic activation
• Dual Modes: pulse and constant on
• Auto-Off feature
• Quick and Easy Installation
®
Taurus® TCP & Slim
UTA-TA
LASERLYTE
LASERLYTE
LASERLYTE
LASERLYTE
LASERLYTE
L
ASER
L
YTE
J
U
1
C
1
S
1
LASERLYTE
LASERLYTE
LASERLYTE
LASERLYTE
LASERLYTE
LASERLYTE
LASERLYTE
LASERLYTE
* Read instructions completely before installing your laser.
Failure to do so may result in damage to your laser or firearm.
Installation:
•
UNLOAD FIREARM.
•
Attach danger label to side of gun near laser with arrow pointing
toward front sight
1
Place small button provided into button hole in left-side of laser body shell.
2
Place left-side of laser body shell on gun, ensuring proper button placement.
3
Move pre-assembled right-side laser body shell on top of trigger guard and
left-side and gently squeeze both sides together.
ENSURE PROPER BUTTON PLACEMENT.
4
5
From left side (non-battery cover side), insert 2 (Slim) or 3 (TCP) 1/2”
head screws using
the larger .050 hex key provided. Tighten screws until snug.
TCPSLIM
hex
Installation: •
1 2
UNLOAD FIREARM
4
3
5
Mounting on other gun: • UNLOAD FIREARM
1
Uninstall laser from gun.
2
Unscrew the Phillips Head Screw and remove Master Module.
3
Put long button in button hole. Put Master Module in place. Put Phillips
Head Screw back in place. Re-attach laser to gun.
2 3
*Note:
Remove
Phillips Head
Screw
*Note:
Please ensure the
correct Laser body is
being installed on the
correct corresponding
pistol to ensure a
proper fit.
Activation:
1
Press once turns laser on: constant or pulse
2
Press and hold for 5 seconds to change mode.
Second press turns laser off.
3
ON/OFF
1 2 3
ON/OFF
This laser has ambidextrous activation.
ON/OFF
5 sec.
or
ON/OFF
or
Laser Sight In:
1
Use the provided .035 hex key to adjust the sight.
2
Always end adjustments on a clockwise turn.
3
Make final adjustments at shooting range.
1 3
2
Windage
Screw
Windage
right
left
Elevation
down
up
ON/OFF
Moving
Laser
Dot
Loading...