LaserLyte ADP-TRIR-140 User Manual
REV0912
®
• No gunsmithing required, installs in minutes
• Fits all 1 inch diameter magazine tubes
• 3 rails and 5 mounting positions
• Mount lasers and lights for home defense
• Made from 6061 T6 Aluminum
ADP-TRIR-140
®
SHOTGUN TRI-RAIL
UNLOAD YOUR FIREARM!
1
2
3
4
WARRANTY:
The Shotgun Tri-Rail
is
warranted
for three years
from any
manufacturers
defects from date of purchase.
®
30 N. Alamos Drive - Cottonwood, AZ 86326
Phone 928-649-3201 - Fax 928-649-3970
www.LaserLyte.com
INSTALLATION INSTRUCTIONS
ADP-TRIR-140
1
UNLOAD YOUR FIREARM!
2
Slide the TRI-RAIL adapter over the magazine tube.
If the barrel lug restricts the adapter from sliding
on, remove barrel and then slide on. Then reinstall
the barrel.
3
Move the TRI-RAIL adapter into the desired position
on your shotgun. Thread the 2 screws through the
holes and tighten.
4
If you are using a barrel shroud, take the screws out
of the shroud, clamp the 2 tabs in and slide the
TRI-RAIL over the tabs and line up the holes. Thread
with the TRI-RAIL screws and tighten down.
1
2
3
4
UNLOAD YOUR FIREARM!
®
30 N. Alamos Drive - Cottonwood, AZ 86326
Phone 928-649-3201 - Fax 928-649-3970
www.LaserLyte.com
WARRANTY:
The Shotgun Tri-Rail
is
warranted
from any manufacturers
defects from date of purchase.
for three years
Loading...