Congratulations on your purchase of the Laser Link Red Hot! All of our Laser Link
products are designed specifically for those who enjoy playing the game of golf.
The Red Hot is not for every golfer, but in the right hands, it can be a powerful
tool for managing your game. To learn more about the Red Hot and the Laser
Link Distance System, please read through the instruction manual.
STARTING OUT
The Battery
Your new rangefinder comes with a
9-volt alkaline battery included inside
the packaging. Simply install the
battery to get started.
Be careful to install the battery in the correct direction, with the positive receptor
closer to the front of the rangefinder. If the battery door does not close easily,
the battery has been placed incorrectly.
When the battery runs low on power, a low battery indicator will appear on the
left side of the LCD screen. When replacing the battery, use only a 9-volt alkaline
battery. DO NOT use heavy duty or lithium batteries.
OPERATING INSTRUCTIONS
The operating instructions are especially important if you have used our
QuickShot Rangefinder in the past. Though the two rangefinders perform a
similar function, the operation of each is different, and using the Red Hot like
you would the QuickShot will not provide optimal performance.
The minimum range is 5 yards; the maximum range is 400 yards to a
non-reflective target, and 800 yards to our patented Laser Link Reflectors.
Back Front
SCOPE
LCD
DISPLAY
LASER &
RECEIVER
BLACK
“ON” BUTTON
SECURITY
HOOK
BATTERY
DOOR
One button does it all…
Any 9-volt
Alkaline
battery can
be used for
replacement.
TAB
Closed Position Open Position
BATTERY INSTALLATION
NOTE: The maximum range of the Red Hot rangefinder can depend on several
factors, including target characteristics and environmental conditions. For instance,
longer maximum distances may be obtained to targets that are large in size, brightly
colored, or have a shiny finish. Ranging capability can also be affected by lighting
conditions (low light/overcast days will provide best performance), and the angle to
the target (i.e. a target at a 90-degree angle to the laser pulses will provide better
measurement characteristics than a target at a 45-degree angle).
To Use:
1. Hold the Red Hot with the LCD screen facing you.
2. Bring the hand-held unit up to your eye. Aim the scope in the direction of
your target.
3. To fire the laser, PRESS AND RELEASE the black “ON” button located under
your trigger finger. A red dot aiming reference will appear in the scope, and the
distance measurement will be made to where the red dot is aimed.
4. Your distance measurement will be displayed on the external LCD display.
NOTE: The red dot in the scope is simply an aiming reference, not the
actual laser.