DistanceMaster One
GB
08
Laser
650 nm
SPEED
SHUTTER
Laser
02
2 x Typ AAA / LR03
1,5V / Alkaline
DistanceMaster One
x
x · y = m
z
x
x · y · z = m
2
y
y
3
03
Read the operating instructions and the enclosed brochure
„Guarantee and additional notices“ completely. Follow the
instructions they contain. Safely keep these documents for
!
future reference.
Compact laser distance meter for measuring length,
area and volume indoors
DISPLAY:
Measurement point (reference)
a
rear / pin / front
g
e
a
g
h
g
f
b
Display length / area / volume
b
Measurement values / Measurement
c
results Unit m / ft / inch / _‘ _“
Intermediate values / min/max values
d
The bar diagram shows how well
e
d
suited the reection surface is for
measurement.This is particularly
useful for measuring over long
c
distances, dark surfaces or bright
ambient light.
Battery symbol
f
min/max continuous measurement
g
Malfunction / service required
h
1.
2.
4.
Do not look directly into the beam. Lasers must be kept
out of reach of children. Never intentionally aim the device
!
at people.
GB
08
KEYPAD:
1.
ON / Measure /
min/max continuous measurement
2.
length, area, volume
3.
Measurement point (reference)
rear / pin / front
4.
Display lighting ON/OFF /
3.
Unit of measure m / ft / inch / _‘ _“
5.
OFF / delete last measurement values
5.
Laser radiation!
Do not stare into the beam!
Class 2 laser
< 1 mW · 650 nm
EN 60825-1:2007-10
DistanceMaster One
Switch on, measure and switch off:
device on laser on measure device off
1x
1 sec
2x 3x
3 sec
1x
Change unit of measure:
m / ft / inch / _‘ _“
3 sec
Delete the last
measured value:
Change measurement point (reference):
rear (device on) pin front
1x
1 sec
1x
2x
Change measurement function:
length area volume
(device on)
1x
1 sec
1x 2x
Length measurement:
device on laser on measure
1x
2x 3x
1 sec
Area measurement:
area laser on 1. measure- laser on 2. measure ment ment
1x 2x 4x3x
GB
09
Volume measurement:
volume 1. measurement 2. measurement 3. measurement
1x 2x 6x4x3x 5x
min/max continuous measurement:
Press for 3 seconds stop
then release button
3 sec
1x 2x
The LC display shows the max value, the min value and the current value.
Important notices
• The laser points to the location that will be measured.
No objects may get into the laser‘s line of measurement.
• The device compensates the measurement for different room
temperatures. Therefore allow the device a brief adaptation period
when changing locations with large temperature differences.
• The device is only conditionally useable in outdoor areas and cannot
be used in strong sunlight.
• The measurement results of outdoor measurements may be influenced
or falsified by rain, fog and snow.
• In unfavourable conditions, e.g. with poorly reflecting surfaces, the
maximum deviation may be greater than 3mm.
• Carpeting, upholstery or curtains will not reflect the laser optimally.
Measure to flat surfaces.
• Measurements made through glass (window panes) can falsify
measurement results.
• An energy-saving function switches the device off automatically.
• Clean with a soft cloth. Water may not be allowed to penetrate the
housing.
10
GB
DistanceMaster One
Technical Data (Subject to technical changes without notice)
Inside measurement range 0,2 m - 18 m
Precision (typical)* ± 3 mm / 10 m
Laser class 2 < 1 mW
Laser wavelength 650 nm
Power supply
Dimensions (W x H x D) 48 x 112 x 24 mm
Weight (incl. batteries) 109 g
Automatic switch-off
Operating temperature -10°C – 40°C
Storage temperature -20°C – 70°C
* measuring distance up to 10 m with strongly reflective target surface and at room temperature.
The measurement deviation may increase by +/-0.2 mm/m for weakly reflective target surfaces.
Error codes:
Err101:
Replace the battery
Err104:
Calculation error
Err152:
Temperature is too high: > 40°C
Err153:
Temperature is too low: < 0°C
Err154:
Outside the measuring range
Err155:
Received signal too weak
Err156:
Received signal too strong
Err157:
Incorrect measurement or background is too bright
Err160:
The device is moving too much to measure.
2 x AAA 1.5 Volt batteries
30
sec laser / 3 min device
EU directives and disposal
This device complies with all necessary standards
for the free movement of goods within the EU.
This product is an electric device and must be
collected separately for disposal according to
the European Directive on waste electrical and
electronic equipment.
Further safety and supplementary notices at:
www.laserliner.com/info
GB
11
DistanceMaster One
SERVICE
Umarex GmbH & Co KG
– Laserliner –
Möhnestraße 149, 59755 Arnsberg, Germany
Tel.: +49 2932 638-300, Fax: +49 2932 638-333
laserliner@umarex.de
Umarex GmbH & Co KG
Donnerfeld 2
59757 Arnsberg, Germany
Tel.: +49 2932 638-300, Fax: -333
www.laserliner.com
Rev.1213
Loading...