LaserLine 40105 Owners Manual

FCC ID: ZNS40105Report identification number

QUAD00040105_1

FCC Statement in the User's Manual

The 40105 modular transmitter is only allowed to be installed into other devices under license and
instruction of LaserLine Mfg Inc. The user's manual should include the following statement:

This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions:

1) this device may not cause any harmful interference, and

2) this device must accept any interference received, includng interference that may cause
undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

• Consult the dealer or an experienced radio/TV technician for help.

The antenna connector is designed to fit the supplied antenna. Do not modify the antenna or connect
any other type of antenna. If a replacement antenna is required, contact your dealer for an authorized
antenna.

The device is intended and authorized for installation in battery-powered devices only.

Any changes or modifications not expressly approved by the party responsible for compliance could
cause the module to cease to comply with Part 15 of the FCC Rules, and thus void the user's authority
to operate the equipment.

A label must be affixed to the device into which the module is installed. The label should read:

Contains Transmitter Module FCC ID: ZNS40105

-or­Contains FCC ID: ZNS40105

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.

June 23, 2011