EasyLog
Quick Start Guide
EL-MOTE
Welcome!
Let’s set up your EL-MOTE
Before you connect your EL-MOTE, you need to do a few things.
• You’ll need to set up an account on
www.easylogcloud.com so that you can
view your devices remotely.
• Download the EasyLog Cloud App
on your phone or tablet
• Have your WiFi network details to hand
Not an Apple or Android user? Visit the support section on
www.easylogcloud.com for alternative set up methods.
Remove mounting
bracket
Remove battery cover
(do not ret this until
set up is complete)
Connect probe/s
Install AA
batteries
In the EasyLog Cloud App,
go to the menu, select Set
up Device and follow the
on-screen instructions
Once EL-MOTE is connected to
your WiFi network replace the
battery cover and install EL-MOTE
in its place of application
& you’re
ready to go!
View and change device settings using the App or at
www.easylogcloud.com
Device Indication Overview
State Front Button LED Sounder
Device
OK
Fault
Alarm
1 Flash / 5 Sec
1 Flash / 5 Sec
1 Flash / 5 Sec
No Sounder
Single tone ring every 30 minutes
Continuous two tone ring
Visit www.easylogcloud.com for a detailed
visual / sound state indication guide.
Front Button / LED Indicator
Reset Button
Setup Button
Probe 2
RESET
SETUP
Power Adapter
Probe 1
Important Safety Information
WARNING: Failure to follow these safety instructions could result in re, electrical shock,
other injury or damage.
Repairing or modifying
Never attempt to repair or modify this product. Dismantling may cause damage that is not covered
under the warranty. Servicing should only be provided by an approved supplier. If the product has
been punctured or seriously damaged, do not use it and return it to an approved supplier.
Using connectors and ports
Never force a connector into a port. Check for obstruction in the port; make sure that the
connector matches the port and that you have positioned the connector correctly in relation to
the port. If the connector and port do not join with reasonable ease, they probably do not match
and should not be used.
Power supply
Only use 1.5V AA batteries or a genuine EL-MOTE power adapter to power your EL-MOTE data
logger.
Disposal and recycling
You must dispose of this product and batteries according to relevant laws and regulations. This
product contains electronic components and therefore must be disposed of separately from
household waste.
Caution:
Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according
to the instructions.
www.lascarelectronics.com/data-loggers
Sales & Support
Lascar Electronics UK
Telephone: +44 (0) 1794 884 567
Email: sales@lascar.co.uk
Lascar Electronics US
Telephone: +1 (814) 835-0621
Email: us-sales@lascarelectronics.com
Lascar Electronics HK
Telephone: +852 2389 6502
Email: sales@lascar.com.hk
08/12/2017 Issue 2
Loading...