Larson Electronics HALSS-48-2L-T5HO-SFC, HALSS-48-2L-T5HO-PND, HALSS-48-2L-T8-PND, HALSS-48-2L-T8-SFC User Manual

Larson Electronics LLC www.LarsonElectronics.com

9419 E US HWY 175, Kemp, TX 75143 Phone: [phone] Fax: [phone] Email: [e-mail]

Stainless Steel Fluorescent Light Fixture - Corrosion Resistant - Class 1 Div 2 Marine Applications

Part #: HALSS-48-2L

Made in the USA

The Larson Electronics HALSS-48-2L Hazardous Location Fluorescent Lighting Fixture is ETL approved Class 1
Division 2 Groups A, B, C and D - 1598A listed and is specifically designed to withstand high vibration locations
and the rigors of wet and corrosive marine environments.

Click here to see the LED version of this light.

The HALSS-48-2L hazardous location fluorescent light fixture is designed for use in wet areas and saltwater-marine
environments where corrosion resistance is critical to equipment longevity and safety. This Class 1 Division 2 rated fixture
is constructed of non-corrosive materials including a stainless steel housing, a poured in gasket for reliable sealing and an
impact resistant acrylic diffuser. Corrosion resistant stainless steel latches secure the lamp cover to the housing and
provide a firm lock against the poured in seal to prevent drips and water intrusion.
This fixture is ETL 844 rated and Class 1 Division II, Groups A, B, C, D approved. The HALSS-48-2L also carries 1598A
and 595 outdoor marine ratings and meets US Coast Guard specifications.

Page: 1

Larson Electronics LLC www.LarsonElectronics.com

9419 E US HWY 175, Kemp, TX 75143 Phone: [phone] Fax: [phone] Email: [e-mail]

Click Photo to Enlarge Click Photo to Enlarge Click Photo to Enlarge

This fixture is designed for heavy duty use in applications where intense vibration and corrosive environments may be
encountered. Stainless steel construction, high impact acrylic lamp covers, and a Class 1 Division 2 ETL rating make this
light ideal for hazardous locations that require illumination with above average dependability.
NOTE ON LAMPS: This fixture comes equipped with F54-T5/850/HO – 54 Watt lamps producing 5,000 lumens per bulb,
a 5000 Kelvin color and a 20,000 hour rated service life. We offer F48-T12/HO – 4050 lumens per bulb, 12,000 hours life,
4100 Kelvin color and F32-T8/841 – 2950 lumens per bulb, 24,000 hours life, 4100 Kelvin color tubes as lamp options for
this fixture. The HALSS-48-2L has an electronic multi-voltage ballast and works with 120 Volt 60 HZ, 220 Volt 50 HZ, 240
Volt 60 HZ and 277 Volts 60 HZ. 24 Volt models available on request for an additional $100 per unit charge.
Standard Flange Brackets: Stainless steel bracket mounts attached at each end of the fixture enables it to be simply
secured to any surface. The mounts provide flexibility in setting the angle of the fixture. Three through holes provide
sufficient mounting for any environment.
Suggested Applications: The HALSS-48-2L is designed for marine wet and damp locations, where corrosion resistant
fluorescent lights are required. This lamp is also ideal for locations where heavy vibratory conditions are present. This
includes petrochemical facilities, lubrication pits, oil drilling rigs, crew quarters, solvent/cleaning areas, water treatment
areas, processing plants and marine loading docks.

Made in USA Quality Lamp Options

1. Each unit dialectically tested.

2. Fixture arrives assembled and lamped to reduce installation time and
cost. Flange type stainless steel mounts attached at each end of the fixture
enables it to be simply secured to any surface.

3. Fixture housing constructed of 14 gauge stainless steel..

4. Relamping done via stainless steel snap locking latches which allow the
operator to remove the door and access the lamps.

5. Lamp cover-diffuser constructed of high impact acrylic for corrosion
resistance and lamp protection.

6. 1/2 inch, threaded access hole for wiring conduit.

Page: 2

F54-T5/850/HO – 54 Watt, 5000 lumens per bulb, 20,000 hours life, 5000

Kelvin color

F48-T12/HO – 4050 lumens per bulb, 12,000 hours life, 4100 Kelvin color
F32-T8/841 – 2950 lumens per bulb, 24,000 hours life, 4100 Kelvin color
F48-T8/HO - 48 watt, 4000 lumens per bulb, 18,000 hours life, 4100 Kelvin

color (Suffix -T8HO)