ASSEMBLY INSTRUCTIONS
READ
&
SAVE
INSTALLATION
&
OPERATION
INSTRUCTIONS
·
·
TOOLS & MATERIALS REQUIRED
Screwdriver
FOR YOUR SAFETY WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU ARE WORKING
ON IS SHUT OFF; EITHER THE FUSE IS REMOVED OR THE CIRCUIT BREAKER IS SHUT OFF. GENERAL
You don’t need special tools to install this fixture. Be sure to follow the steps in the order given. Under no circumstances
should a fixture be hung on house electrical wires, nor should a swag type fixture be installed on a ceiling which contains a
radiant type heating system. Read instructions carefully. If you are unclear as to how to proceed, consult a qualified
electrician. NOTE: Proper wiring is essential for the safe operation of this fixture.
1. Be sure to read these instructions and review the diagrams thoroughly before beginning.
2. Electrical connections must be in accordance with local codes,ordinances,or the National Electric Code.
If you are unfamiliar with methods of installing electrical wiring,secure the services of a qualified
licensed electrician.
3. Before starting the installation,disconnect the power by turning off the circuit breaker or by removing
appropriate fuse at fuse box.Turning the power off at the light switch is not sufficient to prevent
electrical shock.
1. If replacing an existing fixture,disconnect and remove old fixture.Expose the supply wiring from outer
fixture.
2. If your fixture is supplied with three machine screws,thread the long machine screws into the opposite
side of outer fixture.While supporting the fixture,make electrical connections.
Connect white wire(s) from fixture to white neutral wire from supply circuit.Connect black wire(s) to black
hot wire from supply circuit.Connect green wire to green or bare wire or grounding screw on mounting bracket.
In all cases grounding conductor to earth must be used.Use UL/CSA Listed wire connects suitalbe for the
size,type,and number of conductors.No loose strands or loose wires should be present.Secure wire connectors
with UL/CSA Listed electrical tape.
1. Spread electrical splices so black wires are on one side of outlet box and white wires on the other.
2. Attach assembled unit to outer fixture by using two screws and brass nuts,or the threaded stem with nut
provided.
3. Install light bulbs(not provided) and cover assembly.Some models employ a twist off top cap to allow access
to bulbs.
4. CAUTION: Refer to the relamping label located near lampholder for recommended maximum wattage.
Do not exceed recommended wattage.
5. Use weather resistant caulk to seal around top and side perimeter of fixture back late.Leave bottom
uncaused to allow for condensation evaporation.
6. Restore electrical power.
Wire Cutters · Adjustable Wrench · Wiring Supplies
WARNING
GENERAL
PREPARE THE FIXTURE
NOTE:First turn off electricity
ELECTRICAL CONNECTIONS 120V～, 60Hz
FINAL ASSEMBLY
Loading...