Page 1
White or
HOUSE
Black
WIRES
(Hot)
Smooth
FIXTURE
WIRES
Black or
Ribbed
WIRES
FIXTURE
Bare Copper(Ground)
FIXTURE
WIRES
Copper
(Ground)
HOUSE
(Neutral)
WIRES
White
Bare
Green or
WIRES
HOUSE
Listed
U
L
R
INSTALLATIONINSTRUCTIONS
ForWallMountFixture
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
MOUNTING THE FIXTURE
Installation (see fig.1)
1. Disconnect power at main electrical panel before
installation.
2. Thread the two mounting screws about 1/4 ” into the
pre-drilled holes in the mounting plate, spaced about the
same distance apart as the holes in the fixture back plate.
Attach the mount ing plate to the junction box using two
junction box screws . The side of the mounting plate
marked “ GND ” must face out.
3 . Guide fixture wires through hole in center of mounting
plate.
4. Follow wiring instructions carefully (see fig.2)
5. Place the fixture body (D) over the mounting plate so the
mounting plate studs protrude through the cover plate
holes and screw cap nuts (E) onto the mounting screws .
6 . Attach the glass shade (C) and collar ring (B) on lamp
holder, then lock it securely with check ring (A).
7. Attach the finial (F) and fixture body (D).
8
.
Install
8
.
Install
8
8 .
. Install
Install the
specifications.
specifications.
specifications.
specifications. DO
WATTAGE
WATTAGE
WATTAGE
WATTAGE RATING!
the
light
the
light
the light
light bulbs
bulbs
bulbs
bulbs in
DO
DO
DO NOT
RATING!
RATING!
RATING!
in
accordance
in
accordance
in accordance
accordance with
NOT
EXCEED
NOT
EXCEED
NOT EXCEED
EXCEED THE
with
the
with
with the
THE
THE
THE MAXIMUM
fixture
the
fixture
the fixture
fixture
MAXIMUM
MAXIMUM
MAXIMUM
Wiring (see fig.2)
1. Connect the electrical wires as follows. Connect the
Black wire from the fixture to the black house (hot)
Wire. Connect the white wire from the fixture to the white
(neutral) house wire. Make sure all wire nuts are secured.
You
may wrap the connections with electrical tape. If
your outlet box has a ground wire (green or bare copper)
connect fixture’s ground wire to it. Otherwise attach the
bare copper fixture wire to the green ground screw on the
mounting plate .
2.Tuck the wire connections neatly into the wall junction
box.
’
s
’
s
’
’
s
s
F ig.1
Fig. 2
Loading...