Page 1
Supply Wire
Mountin Plate
Fixture Ground Wire
Fixture Wire
Mounting Screw
Junction Box
D
C
B
A
White or
HOUSE
Black
WIRES
(Hot)
Smooth
FIXTURE
WIRES
Black or
Ribbed
WIRES
FIXTURE
Bare Copper(Ground)
FIXTURE
WIRES
Copper
(Ground)
HOUSE
(Neutral)
WIRES
White
Bare
Green or
WIRES
HOUSE
Listed
U
L
R
INSTALLATION
INSTRUCTIONS
Wall
For
Wall
For Wall
Wall Mount
Mount
Mount
Mount Fixture
Fixture
Fixture
Fixture
WARNING! SHUT POWER OFF A T FUSE OR CIRCUIT BREAKER .
MOUNTING THE FIXTURE
Installation (see fig.1)
1. Disconnect power at main electrical panel before
installation.
2. Thread the two mounting screws about 1/4 ” into the
pre-drilled holes in the mounting plate, spaced about
the same distance apart as the holes in the fixture back
plate. Attach the mounting plate to the junction box
using two junction box screws . The side of the
mounting plate marked “ GND ” must face out.
3. Guide fixture wires through hole in center of mounting
plate.
4. Follow wiring instructions carefully (see fig.2)
5. Place the fixture body ( C ) over the mounting plate ，
aligning the hole with mounting screw, then screw the
ball nuts ( D ) onto the mounting screws .
6. Attach the glass shade ( B ) on to the lamp holder, then
lock it securely with check ring (A).
7
.
Install
7
.
Install
7
7 .
. Install
Install the
fixture
fixture
fixture
fixture
THE
THE
THE
THE MAXIMUM
the
light
the
the light
’
s
specifications.
’
s
specifications.
’
’
s
s specifications.
specifications. DO
MAXIMUM
MAXIMUM
MAXIMUM
bulbs
light
bulbs
light bulbs
bulbs in
in
in
in accordance
DO
DO
DO NOT
WATTAGE
WATTAGE
WATTAGE
WATTAGE
accordance
accordance
accordance with
NOT
NOT
NOT EXCEED
RATING!
RATING!
RATING!
RATING!
with
with
with the
EXCEED
EXCEED
EXCEED
Wiring
Wiring
Wiring
Wiring (see
1. Connect the electrical wires as follows. Connect the
(neutral) house wire. Make sure all wire nuts are secured.
You
your outlet box has a ground wire (green or bare copper)
connect fixture’s ground wire to it. Otherwise attach the
bare copper fixture wire to the green ground screw on the
mounting plate .
2.Tuck the wire connections neatly into the wall junction
the
the
the
(see
fig.2)
(see
fig.2)
(see fig.2)
fig.2)
Black wire from the fixture to the black house (hot)
Wire. Connect the white wire from the fixture to the white
may wrap the connections with electrical tape. If
box.
F
F
F
F ig.1
Fig.
Fig.
Fig.
Fig. 2
ig.1
ig.1
ig.1
2
2
2
Loading...