Page 1
White or
HOUSE
Black
WIRES
(Hot)
Smooth
FIXTURE
WIRES
Black or
Ribbed
WIRES
FIXTURE
Bare Copper(Ground)
FIXTURE
WIRES
Copper
(Ground)
HOUSE
(Neutral)
WIRES
White
Bare
Green or
WIRES
HOUSE
Listed
U
L
R
INSTALLA TIONINSTRUCTIONS
ForWallMountFixture
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
MOUNTING
MOUNTING
MOUNTING
MOUNTING THE
THE
FIXTURE
THE
FIXTURE
THE FIXTURE
FIXTURE
Installation (see fig.1)
1. Disconnect power at main electrical panel before installation.
2. Mount the back plate to the wall with the plastic anchors ,
the wood screw (G) and the two box screw (F). The side of the
back plate marked “ GND ” must face out.
3 . Guide fixture wires through hole in center of back plate.
4. Follow wiring instructions carefully (see fig.2)
5. Place the fixture body (A) over the back plate so that the back
plate studs protrude through the cover plate holes and screw cap
nuts (E) onto the long screws (H) .
6 . Attach the glass shade (B) and collar ring (C) on lamp holder,
then lock it securely with check ring (D).
7. Install the light bulbs in accordance with the fixture’s
S pecifications. DO NOT EXCEED THE MAXIMUM
WATTAGE
RATING!
F ig.1
Wiring (see fig.2)
1.Connect the electrical wires as follows. Connect the
Black wire from the fixture to the black house (hot)
Wire. Connect the white wire from the fixture to the
white (neutral) house wire. Make sure all wire nuts are
secured.
tape. If your outlet box has a ground wire (green or bare
copper) connect fixture’s ground wire to it. Otherwise
attach the bare copper fixture wire to the green ground
screw on the circular str a p.
2.Tuck the wire connections neatly into the wall junction
box.
You
may wrap the connections with electrical
Fig. 2
Loading...