Lara 5276, 5277, 5278, 5279, 5280 User Manual

...

1/10

LARA Intercom

5276, 5277, 5278, 5279, 5280, 5281 02-59/2016 rev.:4

LARA Intercom

LARA

LAN

LARA

www.elkoep.com

INTERNET RADIO Supported data transfer formats: CONTROL / SETTINGS Front panel: Remote control: Communication Ethernet: Button RESET: INTERFACE ETHERNET Communications interface: Connector: Max. cable length UTP with power: DISPLAY Type: Resolution: Visible surface: POWER SUPPLY PARAMETERS Supply: Min. input: Max. input: AMPLIFIER PARAMETERS Ampliﬁ er: Max. ampliﬁ er output INPUTS / OUTPUTS Microphone: Audio input: Audio output 1: Audio output 2: CONNECTION Terminal block: OTHER DATA Working temperature: Protection: Overvoltage category: Pollution degree: Installation: Dimensions: Frame - plastic: Frame - metal, glass, wood, granite: Weight - plastic:

mp3, ogg, acc

touchscreen buttons

IR remote control (part of supply)

via PC setting up and communicating SW LARA Conﬁ gurator

restart product / reset product to factory settings

10/100 Mbps

RJ45 50m

color OLED

128x128 pixels

26 x 26 mm

PoE 24 V DC (max. 27 V DC) / 1.25 A

1.4 W

26W (peak at maximum playback performance)

stereophonic class D with digital output control

2 x10 W/8 Ω

yes

3.5 stereo jack

terminals LINE OUT (used for external ampliﬁ er)*

terminals OUT L/OUT R (speaker output from int. ampliﬁ er)

0.5 - 1 mm

(audio outputs)

0 .. + 55 °C

IP20

II. 2

in an installation box

85 x 85 x 46 mm 94 x 94 x 46 mm

87 g (plastic frame)

Congratulations on purchasing your LARA Intercom device (Internet radio in a switch). The instruction manual provides information on installing and operating the device. The instruction manual is always a part of the supply. Only perform installation after becoming thoroughly familiar with this User Guide and device functions. Problem-free function of the device also depends on the way it was shipped, stored and handled. If you notice any signs of damage, deformation, malfunction or a missing part, do not install this product and return it to the point of sale. At the end of its service life, the product and its parts must be treated as electronic waste. Before starting the installation, make sure that all wires and connected parts are not under voltage. When assembling and performing maintenance, you must uphold safety regulations, standards, directives and special provisions for working with electrical equipment. For successful installation, you will need: LARA Intercom, a set of speakers, PoE power source, UTP cable with RJ45 connector, cable for speakers, PC with the application LARA Configurator. To protect yourself from electrical shock, connect only safety extra-low voltage (SELV) circuits. For example power supplies PoE (SELV) or LAN circuits (SELV circuits). Other power supplies (ELV) and WAN circuits (TNV circuits) should not be connected directly to product. Warning: some LAN and WAN ports use the same connectors RJ-45 so be careful when connecting a product.

• LARA Intercom o ers users 5 di erent functions and expands even more options to Lara Radio - music players and internet radio stations within the range of LOGUS90 switch designs.

• LARA Intercom provides an extra functionality and videophone intercom.

• Thanks to videophone function, now it is possible to have a voice communication between LARA and the sound of the door (IP Intercom), so with someone visiting and standing in front of the house, we can see that on LARA display as part of this function which increases the security feeling and safety besides of course, the comfort for the user.

• LARA Intercom is equipped with an OLED colored display with the size of 1.5“, which is used to transfer images and sounds from the door camera properly. The display also shows basic information about playing music, which also serves the orientation in the menu settings, etc.

• The intercom function can also be used for communications between all the family members throughout the whole house, thanks to two way voice communications possibilities between di ernt LARA units.

• LARA Intercom continues to offer three functions that are also supported by LARA Radio - when connected to the Internet, it can play streaming radio stations and you can store up to 40 of them. But you can also select from thousands of radio stations from across the globe, which provide data for correct connection.

• LARA Intercom can play content from an external music source, which can be an smart phone or e.g. an MP3 player. These devices are connected to a 3.5mm stereo jack audio input, located underneath the front panel.

• LARA Intercom can also play audio files from central data storage, onto which Logitech Media Server is installed. This LARA function can therefore be used within the complex iNELS system or as an entirely independent home automation device. When used within iNELS, control is a part of the complex application iHC. If using with NAS data storage, the application LARA NAS App is available.

• Touch control is performed on the device front panel (six capacity buttons available), or by infrared remote control, which is included in the product packaging. The basic device settings (network connection, language, audio input) are performed via the display and a simple menu controlled from capacity buttons on the device front cover. Further settings (selection of stations, connection with the server, updating firmware, etc.) are configured via computer and the software LARA Configurator.

• LARA Intercom has an integrated amplifier with 2 x 10 W output, thus greatly facilitating device installation in places where such output suffices. LARA is used e.g. to provide premium sound to the kitchen, waiting rooms, offices, reception desks, entrance halls, operating rooms or wellness facilities.

• LARA is powered by PoE with maximum voltage level 27 V DC / 1000mA. So connecting and communicating with just one cable (UTP) is a major advantage.

• For LARA, an entire series of accessories is ready for connection (PoE adapters, PoE switches), speakers (in a frame, walls or ceilings) and installation (cables, box, etc.).

• Complies with standards IEEE 802.3u (100BASE-Tx).

• Automatic cable crossing detection of Ethernet cable - MDIX.

Before you begin

Charakteristic

1. Connect LARA and switch

3. Setting of LARA through LARA con gurator

2. Connect speakers to LARA

Easy installation in 3 steps

* The cable from the LINE OUT terminals must be shielded, max. length should not exceed 5m.

Technical parametres

Speaker

(8, 16, 32 )

Speaker in design

LOGUS

21581

External

music

source

WiFi router with PoE

01.01.2013 12:54

STATION:

Radio

NOW PLAYING:

Radio

PLAYING ...

MP3

128

Notebook / PC

2/10

LARA Intercom

5276, 5277, 5278, 5279, 5280, 5281 02-59/2016 rev.:4

LARA Radio

LARA Intercom

www.elkoep.com

Hardware installation

Requirements for installation environment:

- The product cannot be placed where it is exposed to moisture or excessive heat.

- Place the product at a spot where it can be connected to the Ethernet network. The Ethernet cable with PoE

supply should have a short a distance as possible between the player and PoE source due to voltage drop occurring as the distance grows. Also use quality cables and connectors of a renowned brand for installation.

- Never install the player without its installation box, and it is prohibited to mount it directly into the wall, e.g. into

drywall partitions, where the device chassis would be directly wrapped in insulation material.

- Distributing individual elements of the installation must be de ned prior to actual installation, prior to

interference (cutting) into walls or installation of boxes.

PoE (Power over Ethernet) is fed along a data network cable, without the need to provide power to the machine by another separate cable.

Description of installation: Install the bottom part of the LARA player into the box KU, we recommend a box that enables mounting devices with greater depth.Connect the speaker cables into the terminals OUT L +/- OUT R +/-. You can connect the input to an external amplifier into the terminals LINE OUT L, LINE OUT R, GND. Snap the Ethernet cable into the RJ45 connector. Secure the device using the installation box screws. Snap the upper part of the player into the design frame LOGUS

. Snap the upper part of the player with the frame to the lower part of the player. Connection of these two parts must be performed with care to avoid damaging the connectors. Connect the other end of the Ethernet cable to the PoE switch or via the PoE adapter to the Wi-Fi router, switch. After providing power, the display shows the system information, then after around five seconds the main display of the player.

External ampli er

Output of speakers, audio cables

speaker output (W)

2 x 4 Ω 2 x 20W

2 x 8 Ω 2 x 10W

2 x 16 Ω 2 x 5W

2 x 32 Ω 2 x 2.5W

When installing the speakers, use quality audio cables with minimum diameter 0.5 mm, with maximum length of 30 m. It is best to have the same cable length for the right and left channels.

left speaker right speaker

Options of design of the LARA player

Radio Music Videophone Intercom Audio zone

Connection

In-wall speaker

Installation box

Ceiling speaker

Box for surface mounting

Surface mounting

Flush mounting

(ada pted to be mounted inside the wall)

•LARA - can be mounted inside your wall (installation box) or o ers a surface mounting option.

- -

 

3/10

LARA Intercom

5276, 5277, 5278, 5279, 5280, 5281 02-59/2016 rev.:4



























www.elkoep.com

Description and control of player

Long press

Short press

Repeated pressing

Description of display in basic display

Date

Display of actual station name

Display of station name as it is listed on the Internet

Bit Rate*

Time

Volume

Performed action

Graphic equalizer

Hidden button RESET

- In the opening (in the upper part of the cover), for pressing use a thin object, i.e. a paper clip

 / Short press

- navigating in the list of assigned Radios

- switching songs in the Audio Zone

- navigating in the Intercom list

Short press - switching between the Radio, AUX Input and Audio Zone

Long press - switches o the device

Short press - PLAY / PAUSE

Long press - input to settings

Short press

- volume up

- move up between rows

Short press

- volume down

- move down between rows

IR sensor of remote control

Connector for audio inputof external music source for AUX IN

* Displaying the transmission quality (transmission speed tells what volume of information is being

transferred per unit of time. The basic unit of the displayed transmission speed is a kilobit per second).

Control

Playback

switching between the Radio, AUX Input and

Audio Zone:

Radio: Input AUX:

The input AUX IN is used to connect external audio devices such as a mobile phone, mp3 player and others.

A 3.5 mm jack provides connection. In this mode, the player functions as an audio ampli er.

When activating the input, the volume on the player is set ( xed) at 100%.

You can control only on a connected external audio device.

External

source music

Switching between modes is performed by a short touch.

Audio zone:

PLAY / PAUSE Switching between songs

PLAY / PAUSE Navigating in the list of assigned

Radios

Short press (during a call) - opening the electric door lock Long press - calling

- switching on / o the Intercom

01.01.2013 12:54

STATION:

Radio

NOW PLAYING:

Radio

PLAYING ....

MP3

128

01.01.2013 12:54

STATION:

Radio

NOW PLAYING:

Radio

PLAYING ...

MP3

128

01.01.2013 12:54

STATION:

Radio

NOW PLAYING:

Radio

PLAYING ...

MP3

128

01.01.2013 12:54

STATION:

Radio

NOW PLAYING:

Radio

PLAYING ...

MP3

128

01.01.2013 12:54

AUX IN

100%

01.01.2013 12:54

Audio zone

ALBUM

TRACK TITLE

WAITING ...

+ 7 hidden pages

Lara 5276, 5277, 5278, 5279, 5280 User Manual

Specifications and Main Features

Frequently Asked Questions

User Manual