Instructions
For charging and storage on the go
Set Up Instructions
Content list
What’s inside the box?
1 x Go2 Case
1 x PDU power strip
1 x divider pack
1 x portable trolley with retractable handle
1 x high tension retractable spring security combination cable lock
2 x
2 x padlocks
Instructions
1. Remove all exterior packaging and recycle waste where possible.
2. Open main device storage compartment and set dividers into place according to the devices that will
be stored inside the case (see image 1
3. Place devices into each compartment, ensure that the device power inlet is towards the top of the case
to allow access for the charging cable.
4.
4. Open the front zipped AC compartment and place charging cables into stretchy cable pockets (2 cable
per pocket).
5. Pull AC mains plugs down through the open base of the pockets and plug into the power strip. Fix the
Velcro tab into place to secure the excess cables into the base of the pocket.
6. Feed the device cable through the cable port at the top of the stretchy pocket, into the main storage
compartment and plug into the device (see image 2
7. Close AC compartment and main device storage compartments. For additional security we recommend
the use of a padlock on both the main device storage compartment and the AC compartment.
)
.
)
.
Image 2Image 1