Specifications and Main Features
- The electrical input requirement stands at the record of 14.4 with a range of 11 being the lower limit while 16 standing the upper limit.
- The electrical output has set an upper limit of 4 signal transducers in ohms.
- The power output requirements have been set at the config of 25 W X 4.
- The sound output amplifiers have been configured to +10dB Bass At 100Hz, Treble at 10kHz.
- Dimensions of the hardware have been set to approx 192 x 178 x 50 mm.
- The set measurements for mounting have been defined as 169 x 182 x 53 mm.
- The total weight is set to 1.75 kg approximated.
For FM Section:
- The Schwann frequence tuning range is set to 87.5MHz - 1080MHZ for china and Europe, US has defined it under a range 87.5-107.9 MHZ and for Russia 65 to 74 MHZ.
- The IF Range has been set at 10.7 MHZ.
- The usable sensitivity stands at -30dB which is equal to 10dBuV measurement.
- The signal to noise ratio is established on 60dB.
- The stereophonic sound separation is fixed at 30dB with a 1KHZ frequency setup.
- The frequency response has been set and ranged between 30 to 15000 hertz.
For AM Tuner Section:
- This ranges for Europe, China, Russia around 522-1620 KHz while US ranges set the requirement to 530-1710 KHz.
- The if range configurations set us back 450 KHZ.
- The user sensitivity is set at -20dB equaling o 28dBuV.
For CD Player Section:
- The VCD Signal System configurations has our options set for PAL to NTSC standards.
- The noise signal to distortion set the config up at 65dB.
- Bandwidth separation is set to 60dB along with 1KHz frequency.
- Distortion is set to an all time low of 0.1%
For DVD Player Section:
- The total bandwidth frequency ranges from 5hz to 20,000hz.
- The dynamic range spec is labeled at 98dB.
- The signal to noise is set to 73dB.
- The thd and flutter is set under limit that is defiantly measurable.
Please Note: Due to changes between systems and the addition or removing of some structures all values are subject to change and may be different when observed.
Frequently Asked Questions
Q: What voltage is necessary to operate the device?
A: 14.4V conventional current is necessary, giving a range of 11-16V as allowance.
Q: What is the maximum power output of the device?
A: 25W X4 is what you are looking for, as that is the maximum power output of the device.
Q: What kind of discs does this device support?
A: If it is a DVD or CD, or rather an MP3 or VCD, the device readily accepts it all.
Q: What steps need to be taken in order to reset the device?
A: The front panel can be taken off and a ball point can be used to press down on the base’s reset button.
Q: How can the volume be turned up when no sound can be heard?
A: Sound can be muted by using the remote control, it can also be turned back up by checking volume limits.
Q: What range does the FM mode cover?
A: For an FM device the ranges China and Europe are 87.5-108 MHz, the US has 87.5-107.9 MHz and Russia has 65-74 MHz.
Q: What should I do if the CD does not play all the way through and has errors?
A: Make Sure the disc has no scratches or any dirt that can confuse the CD into reading errors or slowing down.
Q: What would be the best settings for bass and treble?
A: 100hz bass and 10khz treble, is what I believe would work best and maximum settings of +10DB should be used.
User Manual
Loading...