Lanzar VBD700 Owners Manual
SPECIFICATION
GENERAL
Supply Voltage DC 12V. Negative Ground
Current Consumption Max.7A
Power Output 7W X 4 ( Measured at DC 14.4 V )
Unit Dimensions 178[W] X 165[D] X 50[H] mm.
FM SECTION
Frequency range 87.5MHz -107.9MHz (USA.)
87.5MHz - 108.0MHz (EUR.)
Effective sensitivity 3uV.
I.F Frequency 10.7MHz.
AM SECTION
Frequency range 530KHz - 1710KHz (USA.)
522KHz - 1620KHz (EUR.)
Effective sensitivity 40dB.
I.F Frequency 450KHz
VBD700
INSTRUCTION MANUAL
RCA LINE OUT (OPTION)
Output CD Max. 1000 200mV
CD PLAYER
System Compact Disc Audio System.
Suitable CDs CD,CD-R,CD-RW Disc
Signal format Sampling frequency 44.1KHz.
NO. of quantization bits 1bit.
Frequency characteristics 20Hz-100Hz < 5dB
10KHz-20KHz < 5dB.
S/N Ratio to CD 50dB [1KHz]
Number of channels 2 STEREO channels.
+
-
\
\
ANTI-THEFT FLIP DOWN DETACHABLE SYSTEM
AUTO-LOADING DISC COMPACT DISC PLAYER
AM/FM-STEREO DIGITAL PLL TUNING RADIO
INFRARED REMOTE CONTROL
http://www. lanzar. com
TROUBLE SHOOTING
Preface
Thank you for purchasing this car audio product.
Please read this manual carefully before operating this car audio product.
Please keep this manual for future use. If will be helpful to you if you are encounter any
operational problem.
Selecting fine audio equipment is only the start of your musical enjoyment.
Now it is time to consider how to maximize the enjoyment you will get from
knowing how to work your new car stereo receiver.
We hope you enjoy using this product and encourage you to always listen at
a moderate, safe sound level to avoid any possible hearing damage or loss.
If you listen to excessively loud sound over time, your hearing can adapt to
higher volumes and what sounds "normal" to you may be quite harmful and
can cause you to have permanent hearing loss. So please practice "safe sound"
and always listen at moderate sound levels only.
Start with your volume control at the lowest setting, and slowly increase the level
until you can hear it comfortably and clearly, free from distortion.
Once you have established this comfortable sound level, leave it there.
WARNING!
To reduce the risk of fire or electric shock, do not use the unit in the rain or moisture
environment.
To prevent direct exposure to laser beam, do not try open the enclosure.
Visible and invisible laser radiation when open and interlocks defeated.
To protect our environment, do not dispose of electrical equipment in the domestic waste.
Please return any electrical equipment that you will no longer use to the collection points
provided for their disposal.
This helps avoid the potential effects of incorrect disposal on the environment and human
health. This will contribute to the recycling and other forms of reutilization of electrical and
electronic equipment. Information concerning where the equipment can be disposed of can
be obtained from your local authority.
Before using the check list please make all the connections first.
If you still have questions after going through the checklist, please consult
your local customer service representative.
Common Symptoms
There is no power.
The CDs cannot
be loaded.
The CDs are loaded
only halfway into
the CD tray.
The device does
not work correctly
(EJECT, LOAD,
PLAY)
There is no sound.
The operation keys
do not work
The sound of the
CD player skips
No radio reception.
In automatic search
mode the radio does
not stop at a transmitting station.
Cause
The car ignition is switched off.
The fuse has blown.
Presence of CD disc inside the player
The transport screws have not been
removed.
Inserting the disc in upside down
The surface of CD is extremely dirty
or it is damaged.
Temperature inside the car is too
high.
The volume control is set too low.
The device has not been correctly
connected.
1.The built-in microcomputer is not
operating properly due to noise
2.Front panel is not properly fix into
its place
The installation angle is more than
30 degrees
The surface of the road is uneven.
The surface of CD is extremely dirty
or it is damaged.
The antenna cable is not connected. Insert the antenna cable firmly into the
weak.
If the power supply is properly connected to
the car accessory, switch the ignition key to
ON or " ACC " " " .
Replace another fuse according to the wiring
diagram.
Remove the disc in the player then put a new
upward
Remove the transport screws before using.
Insert the compact disc with the label facing
upward
Clean the CD or try another CD, if this works
correctly, the first CD is properly damaged.
Cool off until the ambient temperature returns
to normal
Turn up the volume properly.
Check the power and earth connection
according to the wiring diagram.
1. Switch the device off and on again. Or press
the RESET button to resume the program.
2. Reinstall the front panel
Adjust the installation angle to less than 30
degrees
Wait until the road becomes smoother before
playing the CD.
Clean the CD or try another CD, if this works
correctly, the first CD is properly damaged.
antenna socket of the device.
Tune in to a radio station manually.The transmission signals are too
Solution
Page 10 Page 1
Loading...