LANYA ELECTRONIC USB06H User Manual

The User Spec of OPTIMA 2 BT
Dongle
Revision History
0.1 2009/4/16 Andy Lu Initial draft
0.2
0.3 2009/4/27
0.4 2009/4/27
0.4 2009/8/4
2009/4/23 Andy Lu Add “page device time out” to the flowchart
Modify “pairing” to “paging device list”
Andy Lu 1. Change in button function “After press 7s or more, dongle will
clear the device list. The dongle will enter into pairing mode automatically.”
2. Refer to "Page device" in the flow chart, please add "N<= 5min" beside "Fail".
3. add “clean disconnect” explanation on “Q & A”
Andy Lu 1. modify the function 4.9 to dongle will go to pairing device
automatically after cleaning device list
2. Add “Dongle doesn't try to re-connect to speaker, if it is a clean disconnect.” to appendix #3
Frank Feng 1. Change LED blinking pattern to make the distinction of
different states more obvious
1. Product Introduction
OPTIMA 2 BT Dongle is a Plug and Play device for Windows 2000/XP/Vista and Mac OS. It is easy to install and use. OPTIMA 2 BT Dongle supports bluetooth profiles such asHFP, A2DP and AVRCP.
2. Product Exterior
1. LED Indicator (blue light)
2. Pairing Button
3. Introduction to LED Signals & button function
3.1 The LED light indicates different states with different blinking patterns. The blinking patterns
and their corresponding states are illustrated in the following charts and table.
On
idle (not
connected),
Disconnected
Connected
playing
Paging Device list
Pairing
Off
On
Off
On
Off
On
Off
500ms 500ms 200ms 500ms 500ms 200ms
200ms 500ms 500ms 500ms 500ms 200ms 500ms
500ms 500ms 500ms 500ms 500ms 500ms 500ms 500ms
200ms 200ms 200ms 200ms 200ms 200ms
REPEAT ON UNTIL STATE CHANGE
REPEAT ON UNTIL STATE CHANGE
REPEAT ON UNTIL STATE CHANGE
REPEAT 8 Times
Loading...
+ 5 hidden pages