LANYA ELECTRONIC SPRAY User Manual

TO TURN OFF
When not in call mode press and hold the nozzle
until the voice command indicates the speaker is
off. The red LED will flash five times.

PAIRING
When powered off press and hold the nozzle until
the voice command indicates it is in pairing mode
(Red and blue LEDs flash alternately.)

PAIRED
The voice command will indicate the speaker has

13

been paired with your device. The LEDs will then
turn off.

PLAY/PAUSE

Short press of the nozzle when you play music

PREVIOUS SONG
Twist the dome to the LEFT and hold for 2 seconds
to go to PREVIOUS song, repeat as needed.

NEXT SONG
Twist the dome to the right for two seconds to go to
the next song, repeat as needed

14

VOLUME DECREASE
Twist the dome to the left and release to decrease
volume one increment, repeat as necessary to
achieve desired volume.

VOLUME INCREASE
Twist the dome to the right and release to increase
volume one increment, repeat as necessary to
achieve desired volume.

ANSWER/END A CALL
Short press the nozzle when call comes in, There

15

will be a two tone beep to indicate the call is
picked up. When the call is disconnected the
music automatically starts playing again. To send
a call directly to your voicemail press the nozzle
for 2 seconds.

MUTING
Press the nozzle for 2 seconds when on a call. The
red light will flash twice.

LAST NUMBER RE-DIAL
Double tap the nozzle to redial last number.

Insure that all persons who use the product read

SAFETY

and follow these warnings and instructions:

1. Do not expose the product to rain or water

2. Keep all accessories and electronics out of the
reach of small children.

3. Do not use while driving, biking, walking, and
jogging or where traffic is present.

1716

WARRANTY INFO

1 Year Warranty

Mizco International, Inc. warrants this product to
be free from defects in materials and workmanship
to the original purchaser for a period of 1 Year from
the original purchase date.
Mizco’s responsibilities with regard to this limited
warranty shall be limited solely to the repair or
replacement, at Mizco’s own option, of any product,
which fails during normal consumer use.

18

This warranty does not extend to damage or failure,
which results from misuse, neglect, alteration,
abuse, improper installation, or improper
maintenance.

For manual’s in French and Spanish visit our
website www.mizco.com/ecko

19

Declaration of Conformity with

FCC Rules for Electromagnetic Compatibility

We, Mizco International, Inc., of 80 Essex Ave
East, Avenel, NJ 07001, declare under our sole
responsibility that the product to which this
declaration relates, complies with Part 15 of the
FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause
harmful interference, and (2) this device must
accept any interference received, including

20 21

interference that may cause undesired operation.
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses,
and can radiate radio frequency energy and, if
not installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is

noguarantee that interference will not occur in
a particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged
to try to correct the interference by one of the
following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment

and receiver.

• Connect the equipment into an outlet on a circuit

22 23

different from that which the receiver is
connected.

• Consult the dealer or an experienced radio/TV
technician for help. Mizco International, Inc.,
is not responsible for any interference caused
by unauthorized modifications to this equipment.
Such modifications could void the user’s authority
to operate this equipment.

ICES

This Class B digital apparatus complies with
Canadian ICES-003.

Mizco International Inc.

80 Essex Ave East | Avenel, NJ 07001

All trademarks used under license from IP Holdings Unltd LLC

24

INSTRUCTION MANUAL

Your new Ecko Unltd. Spray is the

most unique Bluetooth wireless speaker.

The Spray offers superb wireless audio streaming.

With a twist of the dome or a short press of the

nozzle you control the experience. The Spray will

be your go to device for streaming audio from your

phone, mp3 player, tablet or laptop.

TABLE OF CONTENTS

WHAT’S INSIDE? 3
FEATURES 4
SPECS 6
USING THE SPRAY
CHARGING 7
PAIRING AND BATTERY 9
AUXILIARY AND CONTROLS 10
SAFETY INFORMATION 17
WARRANTY INFORMATION 18

WHAT’S INSIDE?

Ecko Spray Bluetooth Speaker

3.5mm Audio dubbing cable
USB to micro USB charge cable
USB wall charger
1100mAh removable Li-Ion battery, (Pre-installed)

3

FEATURES

Tech

Built in omni-directional microphone for
hands-free Bluetooth calling.

Stereo Bluetooth with extended dynamic range to
deliver premium wireless audio quality.

Wireless range up to 33 feet (10 meters)

3.5mm audio jack for use with non Bluetooth

4

Up to 10 hours of playtime per battery charge

Swappable Li-Ion battery for extended playtime

For use with mobile phones, mp3 players, tablets or
laptops devices

Controls

Play/Pause
Skip Track/Back Track
Answer/End call

5

SPECS

Bluetooth V2.1 + EDR

Amplifier : 3.2-W/Ch Stereo Class-D Audio Amplifier

Speakers : Two full range high output 40mm (1.6”)
drivers with Neodymium high energy magnets

Twin 45mm (1.8”) base radiators

1100mAh Li-ion rechargeable battery

6

Charging the Spray | Battery status information

USING THE SPRAY

Plug the wall charger directly into an ac outlet.

1. Plug the USB connector into the included wall
charger and plug the other end into the micro
USB port on the Spray.

2. The red LED in the nozzle remains on while
charging . Fully charging the battery may take
up to 2 hours. Once the battery is fully charged
the LED indicator will turn off.

7

3. When the battery is low (under 15%) a beep
will be heard two times in a row. When the
battery is under 5% a beep will be heard five
times in a row.

4. When the Spray is being used and is plugged
into a power source the red LED will remain
on until fully charged.

This Spray is compatible with any mobile phone, tablet,
desktop/notebook or any other device that supports the

A2DP bluetooth profile and all wired devices.

Pairing the speaker with your Bluetooth device

1. Ensure your phone or audio device is on
and the Spray is off.

2. Press and hold the nozzle until the voice
command indicates it is in pairing mode.

3. On your device make sure that Bluetooth is
turned on and then choose “scan for devices”.

4. Select SPRAY from the list of found devices.
The voice command feature will indicate
when the speaker is paired with your device.

98

Important note about wireless audio: Try to avoid being
between your music player and the speaker, it can cause
interference which may result in signal drop out. Just
move your player if this should happen.

Using the audio cable

Connect the audio cable to the Spray jack and
plug the other end into the device. When using
the audio cable you can control the volume from
the Spray or from your device. You cannot use
track controls or the microphone while connected

via an audio cable, you must use the controls on
your device.

Important note: No sound will be heard if the speaker is
paired via Bluetooth and connected via the 3.5mm cable
at the same time. Either disconnect Bluetooth or remove
the 3.5mm cable to resume play.

Changing the Li-Ion battery

Turn the speaker upside down and with a small
coin turn the black screw counterclockwise until it
becomes loose and you can remove the bottom

1110

cover. Note that It will not separate from the
bottom cap piece to prevent it from being lost.
Change the battery with a fully charged battery for
extended playtime.

Controls

TO TURN ON
When powered off press and hold the nozzle until
the voice command indicates the speaker is on
The blue LED will flash five times.

12