LANYA ELECTRONIC BH701 User Manual

User manual

BH701 Bluetooth Headset

1. Overview

The headset contains the following parts as shown in the figure:

(3)

(6)

(1)

(2)

(4)

(5)

Answer/end key (1)
Indicator light (2)
Volume key (3)
Microphone (4)
Earphone (5)
Charger connector (6)

Before you start using the headset, you must charge the battery and pair the headset
with a compatible phone.

2. Charging the headset

This device has an internal, rechargeable battery which must be fully charged before
used for the first time. It takes you about 2 hours to charge the battery full for the first
time. During charging, the indicator shows a steady red. When the battery is fully
charged, the red light will turn off. For the later on charging, it takes about 90
minutes.
You can charge the headset either by using the AC travel charger, USB charging cable
or the car charger depending on the package accessories available. Please check your
package for details. BH701 is intended for use with the chargers that is included in the
package.

The fully charged battery has power for up to 4 hours of talking time or up to 100
hours of standby time.
When the battery is running out of power, the red indicator light starts to flash once
every 15 seconds with buzzer reminder voice. This indicates that the headset needs to
be charged as soon as possible.

3. Switch on or off the headset

To switch on, when BH701 is in off state, press and hold the answer/end key for 4
seconds until the blue indicator light starts to flash for 3 times

To switch off, when BH701 is in on state, press and hold the answer/end key for 4
seconds until the red indicator light flashes for 3 times.

4. Pair the headset with a compatible phone

Pairing is the process of establishing encrypted link between BH709 and Bluetooth
devices.
Step-1 The headset must be powered off before you begin to initiate the paring.
Step-2 press and hold the answer/end key for 7 second until the blue and red light
flash alternatively. The headset is now in paring mode.
Step-3 Activate the Bluetooth feature on the phone, and set the phone to search for
Bluetooth devices. Check the user guide of your phone for instructions.
Step-4 Select the headset (BH701) from the list of found devices.
Step-5 When asked the PIN code, please enter “0000” to pair and connect the headset
to your phone. In some phones you may need to make the connection separately after
pairing. See the user guide of your phone for details.
If the pairing is successful, the headset enters idle state and blue light will flash
flashes 1 time every 5 seconds. The headset’s name appears in the phone menu where
you can view the currently paired Bluetooth devices.
You only need to pair the headset with your phone once.
Note for Multi-link use: In order to pair a second mobile, please press the volume ­button for 6 seconds until the red and blue light flashes alternatively, headset is ready
into pairing mode and you can pair the second mobile. Turn off the headset and
re-turn on it, both mobile was ready under links or connect with first cellphone
manually.
In order to activate the multi-link function, press Volume+ and volume – button at the
same time for 3s until the blue led light stay on for 2S.

Troubleshooting

If you cannot connect the headset to your phone, do as follows:

· Ensure that the headset is charged, switched on, paired with and connected

to your phone.

· Ensure that the Bluetooth feature is activated on your phone.

· Check that the headset is within 10 meter(30 feet ) of your phone and that there are

no obstructions between the headset and the phone, such as walls or other electronic
devices.
If no paring is made over a period of time, the headset will retreat paring mode. You
have to turn off the headset and operate again.