LanReady WUB1900H5 User Manual
802.11b/g /n USB Dongle
High Power Wireless N USB Adapter
User’s Manual
2
Table of Contents
1. Introduction ................................................................................................................. 4
1.1 Package Contents ................................................................................................. 4
1.2 Features ................................................................................................................ 4
2. Installation ................................................................................................................... 5
3. Configuring the Adapter ............................................................................................ 11
4. Wireless Utility ........................................................................................................ 17
4.1 Wireless Information ............................................................................................ 17
4.2 AP List ................................................................................................................. 18
4.3 Profile Settings..................................................................................................... 19
4.4 Configuring Encryption ........................................................................................ 21
4.5 Ad-hoc and Peer-to-Peer Wireless Networks ...................................................... 27
4.6 Wi-Fi Protected Setup (WPS) .............................................................................. 30
4.7 SoftAP…………………………............................................................................... 30
4.7 About ................................................................................................................... 38
Appendix A – Features.................................................................................................. 39
Appendix B – Information .............................................................................................. 40
Technical Support ......................................................................................................... 41
3
1. Introduction
Congratulations on your purchase of the Kozumi’s K-500MWUN Wireless N USB
Adapter. Its high bandwidth combined with extended wireless coverage delivers fast and
reliable connection for all
of your networking applications when used with other Wireless N products.
A full range of security features such as WEP, WPA-PSK, and WPA2-PSK provide the
highest level of wireless network security. The bundled Wireless Utility allows you to set
up the adapter with an easy-to-use user interface. Best of all the Wireless N USB
Adapter works with 802.11g and 802.11b network devices ensuring compatibility with
your existing wireless products.
1.1 Package Contents
Before you begin the installation, please check the items of your package. The package
should include the following items:
• Wireless N USB Adapter
• Installation CD (Driver/Utility/Manual)
1.2 Features
• Industry’s highest wireless data rate with IEEE 802.11n draft specification 2.0
• 64-bit/128-bit WEP encryption, Pre-shared Key (PSK), and Wi-Fi Protected
Access (WPA2 and WPA) support provide full protection for your wireless
connection
• Higher data rate increases the reliability and stability of wireless connections
• Great for environments with higher wireless data traffic requirements
• Fully backward-compatible with 802.11b/g devices
• Works best with other Wireless N products
4
2. Installation
This section provides instructions on how to install the Wireless N USB Adapter.
The driver is installed along with the utility.
Step 1 Insert the USB adapter into an available USB port and turn on your computer.
Step 2 After turning on the computer, Windows will launch the Found New
Hardware Wizard. The Found New Hardware Wizard appears differently depending
on your operating system. Click Cancel to quit the wizard and insert the Installation
CD into your CD drive.
5
Step 3
Driver\RTL8188SU.exe file.
Note: Otherwise, go to Start, Run, and type D:\Driver\RTL8188SU.exe (where D is
the letter of your CD drive) and click OK.
Windows Vista users: At this point, you may get a warning message like the one
below. Make sure that you click Allow to continue with the installation.
Open Windows explorer and browse to the CD and open
6
Step 4 Select language and press Next at the welcome screen.
Step 5 Click Next to continue.
7
Step 6 Click Install to begin install.
8
Step 6 Click Continue Anyway at the Windows Logo Screen. (For Windows 2000, click
Yes at the Digital Signature Not Found prompt).
For Windows Vista, click the Install this driver software anyway button when the
security warning appears.
9
Step 7 Click Finish.
10
3. Configuring the Adapter
This section describes how to connect your wireless adapter to a wireless network.
Note to Windows XP Users:
You must disable the Wireless Zero Configuration Utility in order to use the bundled
Wireless Utility. Please follow the steps below to disable XP’s wireless utility. Windows
Vista users can skip the following instructions and go to Step 1
Double-click on the Wireless Network Connection Icon in the system tray and then
click on Properties or Advanced.
When the new wireless network connection properties window appears, go to the
Wireless Networks tab, uncheck the “Use Windows to configure my wireless
network settings” check box and click OK.
11
Step 1 To open the utility, double click on the Wireless Monitor icon in the system tray
at the bottom right-hand corner of your screen.
12
Step 2 Go to the Available Network tab, select the SSID (Network Name) of the
wireless network you wish to connect to, and double click Add to Profile.
13
Loading...