Lanier RS232 User Manual

MATERIAL SAFETY DATA SHEET
A RICOH COMPANY
Lanier Worldwide, Inc.
2300 Parklake Drive, NE Atlanta, GA USA 30345­2979
Emergency Telephone: 800-526-4371
Section 1: Chemical Product and Company Information
Identity: Product ID: 480-0077 Issued: 06/04/2003
Synonyms & Common Names:
Uses: Chemical
Formula:
Color Developer – Cyan
Developer for Lanier LP036c Development Unit Type 5000 Color Cyan
Lanier LP036c
Mixture
MSDS No.
Supersedes:
Date:
Prepared by:
Approved by:
European
Contact:
CP- 736 None
06/04/2003 EH&S Department 770-496-9500
Larry Choskey, Manager, CEH&S Walter Fricke, Manager, Safety & Environment, Lanier Worldwide, Inc. Im Taubental D-41468 Neuss, Germany +49-2131-387-177
Section 2: Composition / Information on Ingredients
PERCENT CAS No. EXPOSURE LIMITS SOURCE Polyester resin > 80 Confidential Not listed N/a Acrylic resin < 10 Confidential Not listed N/a Silicon compound < 3 7631-86-9 Not listed N/a Organic pigment < 10 147-14-8 Not listed N/a
Section 3: Hazards Identification
HMIS Rating:
FLAMMABILITY = 1 HEALT H = 1 REACTIVITY = 0 SPECIAL = none
Health Hazards, Immediate and Potential): Primary Entry Routes:
Inhalation: Yes Skin: No Ingestion: No
Medical conditions aggravated by exposure: N/A Chronic Effects: No data is available on this product. Carcinogenicity: This product does not contain the carcinogenic substances, which are listed in NTP, IARC, and are regulated
by OSHA.
Section 4: First Aid Measures
Inhalation: Skin Contact: Wash with soap and water. Ingestion: Dilute stomach contents with several
Gargle with water. Remove to fresh air if effects occur. Get medical attention if needed.
Eye Contact:
In case of contact, immediately flush eyes with water for 15 minutes. Get medical attention if needed.
glasses of water. Get medical attention.
Section 5: Fire Fighting Measures
Suitable extinguishing media: CO2, dry chemical, foam or water.
Special protective equipment for fire fighters: none UEL: n/a LEL: n/a
Extinguishing media which may not be used for safety reasons: none
your document management partner
MATERIAL SAFETY DATA SHEET
Page 2 of 3 CP-736
Section 6: Accidental Release Measures
Spill / leak Procedures: If spilled, sweep up using an approved toner vacuum with a 0.5 micron filter or smaller, such as the Atrix AAA Toner Vacuum or 3M Toner Vacuum. Use of a vacuum cleaner not rated for toner particles, could result in a fire or personal injury. Remove residue with soap and cold water. Miscellaneous: Keep product out of sewers and watercourses. Personal protection: Avoid inhalation of dust.
Section 7: Handling and Storage
Special Handling: Cleanse skin after contact before breaks or meals, and end of workday.
Special Storage: Avoid direct sunlight. Keep out of reach of children. Store in a cool, dry place. Below 35C (95F)
Do not handle in areas where the wind blows. Minimize the breathing of dust.
Section 8: Exposure Control and Personal Protection Information:
Respiratory Protection: none required under normal use. Hand Protection: none required under normal use. Eye Protection: none required under normal use. Skin Protection: none required under normal use.
Section 9: Physical and Chemical Properties
CHARACTERISTICS: Appearance: Cyan Melting point: N/a Form: Powder Vapor pressure: N/a Odor: Slight plastic odor Vapor density: N/a Solubility in Water: Insoluble Evaporation rate: N/a Specific gravity: N/a Boiling point: N/a Density: 1.2 g/cm3
Section 10: Stability and Reactivity
Conditions to avoid: none Materials to avoid: none Stability: Stable Hazardous decomposition products: will not occur
Section 11: Toxicological Information:
Ames test negative Acute skin irritation: Non-irritant Acute oral toxicity : 5000mg/kg (rat) Acute allergenic effects: non-skin sensitive Special effects: Carcinogenicity : No data is available on this product.
Section 12: Environmental / Ecological Information
Acute toxicity to fish: not available Bioaccumulation: Not known in bioaccumulation Persistence/Degradability: Not known Acute toxicity to daphnia: Not available Algae inhibition test: Not available
Section 13: Disposal Consideration
Used developer should be disposed of under conditions that meet all federal, state and local environmental regulations. Disposal regulations vary from locality to locality; therefore consult your local Lanier office or the EPA to determine the proper method for disposal. Do not incinerate loose or spilled developer.
Section 14: Transportation Information
International regulations: RID/ADR Not applicable ICAO-TI/ATA-DGR Not applicable DOT 49 CFR Not applicable UN Classification Number Not applicable ADNR Not applicable IMDG Code Not applicable
Specific precautionary transport measures: Avoid direct sunlight. Do not keep over 35?C (95?F). Specific material to avoid: None in normal use.
MATERIAL SAFETY DATA SHEET
Page 2 of 3 CP-736
Section 15: Regulatory Information
Regulation: Not known
Section 16: Miscellaneous Information
Judgment as to the suitability of information contained herein for user’s purposes is the responsibility of the purchaser. Therefore, although reasonable care has been taken in the preparation of this information, Lanier Worldwide, Inc. extends no warranties, makes no representations, and assumes no responsibility as to the accuracy or suitability of such information for application to user’s intended purposes or for consequences of its use. All materials may present unknown hazards and should be used with caution. Although certain hazards are described herein, we do not guarantee that these are the only hazards that exist.
Loading...