Lanier G08 User Manual

A

MATERIAL SAFETY DATA SHEET

Lanier Worldwide, Inc.
2300 Parklake Drive, NE

tlanta, GA USA 30345-2979

Emergency Telephone: [phone]

Section 1: Chemical Product and Company Information

Identity:

Cyan Developer

Product ID: B2309660 Issued: 07/05/2006
Synonyms

& Common
Names:

Uses:
Chemical

Formula:

Developer, Cartridge Cyan

Lanier LD425c, LD430c

Mixture

MSDS No.

Supersedes:

Date:

Prepared by:

Approved by:

CP- 771
none

10/19/2005
EH&S Department 770-496-9500

Larry Choskey, Manager, CHS

Section 2: Composition / Information on Ingredients

Ferrite 75 – 95 65997-18-4 Not listed N/a
Polyester resin 1 – 20 Confidential Not listed N/a
Organic pigment < 1 147-14-8 Not listed N/a

PERCENT CAS No. EXPOSURE LIMITS SOURCE

Section 3: Hazards Identification

HMIS Rating:

FLAMMABILITY = 1 HEALTH = 1
REACTIVITY = 0 SPECIAL = none

Health Hazards (Acute, Chronic, Immediate and Potential): product is stable, nonflammable powder. If used as intended the
product does not present an acute or chronic health hazard.

Health Hazards of Long Term exposure (Chronic): no data is available on this product.
Carcinogenicity: This product does not contain the carcinogenic substances, which are listed in NTP, IARC, and are regulated by

OSHA.

Section 4: First Aid Measures

Inhalation:
Skin Contact:

Remove to fresh air if effects occur. Get medical
attention if needed.

Wash with soap and water. Wash clothing before
reuse. If irritation occurs or is persistent, seek
medical attention.

Eye Contact:
Ingestion:

In case of contact, immediately flush eyes
with water for 15 minutes. Get medical
attention if needed.
Dilute stomach contents with several
glasses of water. Get medical attention if
needed.

Section 5: Fire Fighting Measures

Suitable extinguishing media: CO2, dry chemical, foam or water

fog.

Special protective equipment for fire fighters: none
UEL: n/a LEL: n/a

Extinguishing media which may not be used for
safety reasons: none

Unusual fire or explosion hazards: Dust of this product

at sufficient concentrations can form explosive mixtures
with air.

your document management partner

MATERIAL SAFETY DATA SHEET

Page 2 of 3 CP-771

Section 6: Accidental Release Measures

Spill / leak Procedures: If spilled, sweep up using an approved toner vacuum with a 0.5 micron filter or smaller, such as the Atrix

AAA Toner Vacuum or 3M Toner Vacuum. Use of a vacuum cleaner not rated for toner particles, could result in a fire or personal
injury. Remove residue with soap and cold water.
Miscellaneous: Keep product out of sewers and watercourses.
Personal protection: Avoid inhalation of dust.

Section 7: Handling and Storage

Special Handling:

Special Storage:

Cleanse skin after contact before breaks or meals, and end of workday.
Do not handle in areas where the wind blows.
Minimize the breathing of dust.
Avoid direct sunlight. Keep out of reach of children. Store in a cool, dry place. Below 35C (95F)

Section 8: Exposure Control and Personal Protection Information:

Respiratory Protection: none required under normal use. Hand Protection: none required under normal use.
Eye Protection: none required under normal use. Skin Protection: none required under normal use.

Section 9: Physical and Chemical Properties

CHARACTERISTICS:
Appearance: Cyan Melting point: N/a
Form: Powder Vapor pressure: N/a
Odor: Slight plastic odor Vapor density: N/a
Solubility in Water: Insoluble Evaporation rate: N/a
Specific gravity: ~ 5 g/cm

3

Boiling point: N/a

Section 10: Stability and Reactivity

Conditions to avoid: none Hazardous decomposition products: will not occur
Polymerization: none

Section 11: Toxicological Information:

Ames test: negative
Acute oral toxicity: > 5000mg/kg
Carcinogenicity: no data is available on this product.
Teratogenicity: not available

Section 12: Environmental / Ecological Information

Bioaccumulation: Not known in bioaccumulation
Environmental degradation: not known

Section 13: Disposal Consideration

Used developer should be disposed of under conditions that meet all federal, state and local environmental regulations. Disposal
regulations vary from locality to locality; therefore consult your local Lanier office or the EPA to determine the proper method for
disposal. Do not incinerate loose or spilled developer.