Lanier 5811, 5711 User Manual

Emergency Telephone: [phone]

MATERIAL SAFETY DATA SHEET

Section 1: Chemical Product and Company Information

Lanier Worldwide, Inc.

2300 Parklake Dr., N. E.

Atlanta, GA 30345-2979

Identity:

Cyan Toner for 5711 / 5811

MSDS No.

CP- 325

Product ID: 117-0310 Issued: 9/2/99

Synonyms
& Common
Names:

Uses:
Chemical

Formula:

Cyan Toner for
Lanier 5711, 5811

Lanier 5711, 5811 Color Copier

Mixture

Supersedes:

Date:

Prepared by:

Approved by:

European Contact:

None
9/2/99
Lanier QA/EH&S Department 770-493-2361

Larry Choskey, Sr. Quality Assurance Engineer
Lanier Worldwide, WSM Europe,
Walter Fricke,
Im Taubental D-41468 Neuss, Germany
[phone]

Section 2: Composition / Information on Ingredients

PERCENT CAS No. EXPOSURE LIMITS SOURCE

Polyester resin 85 – 95 % by weight N/a N/a N/a
Pigment 1 – 5 % by weight N/a N/a

*PEL as the product: 15mg/m3 (total dust), 5mg/m3 (respirable dust)
*TLV as the product: 10mg/m3 (total dust), 5mg/m3 (respirable dust)

N/a

Section 3: Hazards Identification

HMIS Rating:

FLAMMABILITY = 1 HEALTH = 1
REACTIVITY = 0 SPECIAL = none

Health Hazards (Acute, Chronic, Immediate and Potential): Minimum irritation to respiratory tract may occur as with exposure to any non-toxic dust.
Inhalation should be avoided. May cause temporary eye discomfort.

Health Hazards of Long Term exposure (Chronic): Not known.

Section 4: First Aid Measures

Inhalation:
Skin Contact: Wash with soap and water. Ingestion: Dilute stomach contents with several glasses of

Remove to fresh air if effects occur. Gargle with water.
Get medical attention if needed. Eye Contact:

In case of contact, immediately flush eyes with
water for 15 minutes. Get medical attention if
needed.

water. Get medical attention if needed.

Section 5: Fire Fighting Measures

Suitable extinguishing media: CO2, dry chemical, foam or water.
Extinguishing media which may not be used for safety reasons: none

Flammability: Non-flammable solid The decomposition products are CO, CO2,. Avoid inhalation of smoke.
Special protective equipment for fire fighters: none
UEL: n/a LEL: n/a

Unusual Fire and Explosion Hazards: Toner material, like most
organic material in powdered form, is capable of creating a dust
explosion.

Section 6: Accidental Release Measures

Spill / leak Procedures: If spilled, sweep up using an approved toner vacuum with a 0.5 micron filter or smaller, such as the Atrix AAA Toner Vacuum or
3M Toner Vacuum. Use of a vacuum cleaner not rated for toner particles, could result in a fire or personal injury. Remove residue with soap and cold
water.
Miscellaneous: Keep product out of sewers and watercourses.
Personal protection: Avoid inhalation of dust.

Section 7: Handling and Storage

Special Handling: Cleanse skin after contact before breaks or meals, and end of workday.
Special Storage:

Miscellaneous:

Store in a cool, dry place. Avoid direct sunlight. Keep out of reach of children. Keep from contact with oxidizing materials.
Do not handle in windy areas. Flying powder may enter eyes. Minimize inhalation of dust. Cleanse skin thoroughly after
contact, before breaks and meals, and at end of work periods.

Section 8: Exposure Control and Personal Protection Information:

Respiratory Protection: none required under normal use. Hand Protection: none required under normal use.

MATERIAL SAFETY DATA SHEET

chemicals.

Page 2 of CP-325

Eye Protection: none required under normal use.
Ventilation: Local exhaust equipment is needed. Skin Protection: none required under normal use.
Exposure Guidelines: USA OSHA (TWA/PEL) : 15mg/m3 (Total Dust); 5mg/m

ACGIH (TWA/TLV) : 10mg/m
DFG (MAK) : 4mg/m

3

3

(Inhalable fraction); 1.5mg/m

(Total dust); 3mg/m

3

(Respirable fraction)

3

(Respirable fraction)

3

(Respirable fraction)

Section 9: Physical and Chemical Properties

CHARACTERISTICS:
Appearance: Cyan Melting point:
Form: Powder Vapor pressure: n/a
Odor: Slight plastic odor Vapor density: n/a
Solubility in Water: Negligible Evaporation rate: n/a
Density: 1.0 – 1.5 Boiling point: n/a
Flammability: Non-flammable solid (according to test

methods of USA 16 CFR 1500.44 and
annex V of EU Directive 84/449/EEC)

Fat solubility: Partially soluble in toluene and xylene

100 – 150°C (softening point)

Section 10: Stability and Reactivity

Conditions to avoid: none Materials to avoid: none Stability: Stable
Hazardous decomposition products: CO and CO2 and other decomposition products when burned.

Section 11: Toxicological Information:

Acute Toxicity: Inhalation: (Data from similar material without ferrite): LC50:>4.93mg/L/4hr (rats) (Mean maximum attainable concentration)

Ingestion: (Data from ingredients of toner): LD50:>5000mg/kg (rats)
Eye: (Data from ingredients of toner): Not classified as irritant, according to OSHA Haz Com Standard and EU Directive 67/548/EEC based on test data
of rabbits.
Sensitizer: No sensitizer according to Annex I of EU Directive 67/548/EEC and strong sensitizer list of FHSA.
Mutagenicity: Ames test negative
Reproductive Toxicity: No reproductive toxic substances according to Annex I of EU Directive 67/548/EEC, California Proposition 65 and DFG.
Carcinogenicity: Carbon Black: IARC 2B (Possible human carcinogen based on animal testing). Not listed in NTP, OSHA(USA) regulation, California
Proposition 65 and Annex I of EU Directive 67/548/EEC.

Section 12: Environmental / Ecological Information

No information indicating any adverse ecological effects.

Section 13: Disposal Consideration

Used Toner should be disposed of under conditions that meet all federal, state and local environmental regulations. Disposal regulations vary from
locality to locality, therefore consult your local Lanier office or the EPA to determine the proper method for disposal. Do not incinerate loose or spilled
Toner.

Section 14: Transportation Information

None. This is not a hazardous product.

Section 15: Regulatory Information

SARA Title III, 313: Chemical name: Chromium(III) and compound 10% weight (maximum)
(as chromium(III) metal) 1% weight (maximum)

Section 16: Miscellaneous Information

Judgment as to the suitability of information contained herein for user’s purposes is the responsibility of the purchaser. Therefore, although reasonable
care has been taken in the preparation of this information, Lanier Worldwide, Inc. extends no warranties, makes no representations, and assumes no
responsibility as to the accuracy or suitability of such information for application to user’s intended purposes or for consequences of its use. All materials
may present unknown hazards and should be used with caution. Although certain hazards are described herein, we do not guarantee that these are the
only hazards that exist.

Information on this data sheet represents our current data and best opinion as to the proper use in handling of this product under normal conditions. On the
basis of the data available to us, this product is not a dangerous substance. One should, however, observe the usual precautionary measures for dealing with