Lang Manufacturing 32S-1 Service Manual

32S RANGE LEG ADAPTER

LEG TO ADAPTER INSTALLATION

Install the leg's threaded stud through the hole in the adapter labeled "C" with the bent flange of the adapter
facing away from the leg.

Screw the 3/4 inch nut supplied in the adapter kit onto the leg stud and tighten.

CASTER TO ADAPTER INSTALLATION

Remove the casters and caster mounting hardware from the box marked "CASTERS".

Place the swivel

Align the caster to the holes in the adapter labeled "B". Note that there are two sets of "B" holes set at

90 degrees from each other. One set will create a left front adapter and the other set will create a
right front adapter.

Install four 1/4 - 20 bolts through the caster base and the adapter holes labeled "B" then install 1/4 -20 nuts
with and washers.

Place the rigid

Align the caster to the holes in the adapter labeled "B". Note that there are two sets of "B" holes set at

90 degrees from each other. One set will create a left rear adapter and the other set will create a
right rear adapter.

Install four 1/4 - 20 bolts through the caster base and the adapter holes labeled "B" then install 1/4 -20 nuts
with and washers.

caster against the leg adapter with the flange of the adapter facing away from the caster.

casters against the leg adapter with the flange of the adapter facing away from the caster.

ADAPTER TO OVEN INSTALLATION

Gently tip the oven back slightly. Caution: Do not tip the oven back far enough to disturb the range
top plates as they are not bolted to the range.

Place the swivel leg adapters into the front corners of the oven so that the adapter is under the flange of the
oven side and front .

Thread one 3/8 inch bolt with lock washer and flat washer into the threaded holes labeled "E" on each of
the leg adapters.

Gently tip the oven forward slightly. Caution: Do not tip the oven forward far enough to disturb the
range top plates as they are not bolted to the range.

Place the ridged leg adapters into the rear corners of the oven so that the adapter is under the flange of the
oven side and back. NOTE: If installing casters place the adapters on the oven so that the casters roll
forward.

Install four 3/8 inch bolts with lock washers and flat washers through the holes labeled "E" in the flange of
the oven and into the threaded inserts of the leg adapter.

P/N: 2M-60902-21 Page 1 of 2 5/95

P/N: 2M-60902-21 Page 2 of 2 5/95