11
Stand alone mode (colour sequences)
For the stand alone mode (STAND ALONE/MASTER), the dip-switch 12 has to be on the ON position. When the projector is
switched on, it will execute the functions set on the dip-switch es.
If the projector has to execute colour sequences, the dip-switches 12 has to be on ON position.
WARNING: The projector in stand alone mode becomes a DMX generator, it is necessary to disconnect that projector
by DMX controller or by the other projector MASTER because generates conflict in the signal.
Setting the dip-switches, it is possible to choose the colour sequence that the projector will execute.
Dip-switch FUNCTION
Dip 1 Sequence mode SQ1
Dip 2 Sequence mode SQ2
Dip 3 Sequence mode SQ3
Dip 4
OFF=Only colour filter
ON=Enable half colour
Dip 5
OFF=Sequence without white
ON=Enable white
Dip 6
OFF=Normal movement
ON=Enable slow movement
Dip 7 Time mode TIME 1
Dip 8 Time mode TIME 2
Dip 9 Time mode TIME 3
Dip 10 Time mode TIME 4
Dip 11 Time mode TIME 5
Dip 12
ON
COLOUR SEQUENCE SETTING
As shown in the following table the projector will execu te the colour from top to bottom and back.
Dip 1 Dip 2 Dip 3 PERFORMED SEQUENCE
off off off
WHITE COL 1 COL 2 COL 3 COL 4 COL 5 COL 4 COL 3 COL 2 COL 1
ON off off
WHITE COL 1 COL 2 COL 3 COL 4 COL 3 COL 2 COL 1
off ON off
WHITE COL 1 COL 2 COL 3 COL 2 COL 1
ON ON off
WHITE COL 1 COL 2 COL 1
off off ON
WHITE COL 1
ON off ON
WHITE COL 2 COL 4 COL 3 COL 1
off ON ON
WHITE COL 3 COL 5 COL 3
ON ON ON
WHITE COL 1 COL 2 COL 5 COL 2 COL 1
In the table, white is enable (Dip 5 in ON position)
Standard colour filters:
COL 1 COL 2 COL 3 COL 4 COL 5
RED YELLOW GREEN BLUE MAGENTA
The colour wheel is seen from the front side of the projector.