Lamotte IRON KIT User Manual
IRON KIT
OCTA-SLIDE 2, 0.5-10 PPM
CODE 3347-01
QUANTITY CONTENTS CODE
30 mL *Iron Reagent #1 *4450-G
4.5g *Iron Reagent #2 Powder *4451-S
4.5g *Ferrous Iron Reagent *4453-S
2 Spoons, 0.05 g, plastic 0696
2 Test Tubes, 2.5-5-10 mL, plastic, w/caps 0106
1 Octa-Slide 2 Viewer 1101
1 Iron Octa-Slide 2 Bar, 0.5 - 10 ppm 4448-01
*WARNING: Reagents marked with an * are considered to be potential health hazards.
To view or print a Safety Data Sheet (SDS) for these reagents go to www.lamotte.com.
Search the four digit reagent code number listed on the reagent label, in the contents
or in the test procedures. Omit any letter that follows or precedes the four digit code
number. For example if code is 4450WT-H, search 4450. To obtain a printed copy,
contact LaMotte by e-mail, phone or fax.
Emergency information for all LaMotte reagents
is available from Chem-Tel:
(US, 1-800-255-3924)
(International, call collect, 813-248-0585)
To order individual reagents or test kit
components, use the specifi ed code number.
Warning! This set contains chemicals
that may be harmful if misused. Read
cautions on individual containers
carefully. Not to be used by children
except under adult supervision.
list
USE OF THE OCTA-SLIDE 2 VIEWER
The Octa-Slide 2 Viewer should be held so
non-direct light enters through the back of
the Viewer.
the Viewer. Insert the reacted sample into
the top of the Viewer. M
reaction to the color standards.
Insert the Octa-Slide 2
atch the color of the
Bar into
PROCEDURES
TOTAL IRON
1
Insert Iron
Octa-Slide 2
Bar (4448-01)
into the
Octa-Slide 2
Viewer (1101)
3
Add 5 drops
of *Iron
Reagent #1
(4450).
5
Use the 0.05g
spoon (0696)
to add one level
measure of *Iron
Reagent
Powder (4451).
#2
2
Rinse test
tube (0106)
.
with sample
water. Fill to
5 mL line.
4
Cap and mix.
6
Cap and shake
until powder
dissolves.
7
Wait 3 minutes.
8
Insert test
tube into
Octa-Slide 2
Viewer.
03:00
9
Match sample color to a
standard.
Record as ppm
color
Total Iron.
Loading...