Page 1
Salt
in
Water
Sodium Chloride Test Kit
Code 3156
802 Washington Ave. • Chestertown • Maryland • 21620 • USA
800-344-3100 • +1 410-778-3100 • Fax 410-778-6394
Visit us on the web at
WARNING: Cancer and Reproductive Harm www.P65Warnings.ca.gov
Test Procedure
1. Fill the tube (0715) to the 5 mL line
with the sample water.
2. Add three drops of *Chloride Reagent #1
(4504) to sample. Swirl to mix. Solution
will turn yellow.
3. Holding *Salt Titrant (3741LWT) in a
vertical position, add one drop at a time,
swirling to mix, until the color changes
from yellow to milky orange. Count the
number of drops required to reach the
final color. Add titrant slowly, allowing
each drop to form fully on the tip before
dispensing. Rapid titration with
incomplete drops will result in
erroneous high readings.
4. Multiply number of drops used
by 200. Record result as ppm salt
(sodium chloride).
Salt Titrant will stain. Avoid contact with
*
skin. Place tip of titrant bottle well into
titration tube while dispensing.
Store the kit at room temperature.
*Potential health hazard. Read SDS at lamotte.com.
Emergency information for all LaMotte reagents is available
© 2022 LaMotte Company, All Rights Reserved | 63156 | 02.11.2022
from Chem-Tel (US: 1-800-255-3924)
(International: call collect, 813-248-0585).
Find Quality Products Online at: sales@GlobalTestSupply.com
www.GlobalTestSupply.com
Loading...