Lakeside Foodservice V5211 Installation Manual

OVAL

Ingenuity on Wheels

TM

ADJUSTMENT INSTRUCTIONS

For Models

V5210, V5211, V5212, V5213, V5214

Refer to pictures at right before starting.

WEIGHT ADJUSTMENT

Dish diameter and weight determine how many springs should
support your dishes. To insure smooth operation, use an equal
number of springs on both sides of the dispenser. Always
unhook lower end of springs only. Leave unused springs hang
for future use.

Use the following chart as a guide to determine approximately how
many springs to use.

Dish Size Springs Required

9¾” to 10½” Long 6 to 10
10¾” to 11½” Long 8 to 14
11¾” to 12½” Long 10 to 15
12¾” to 13½” Long 12 to 16
13¾” to 14½” Long 14 to 18

a. Place ten dishes into the unit directly on top cap.
b. If the dishes are above the top of the dish guides, one or more
of the springs must be unhooked. Remove the dishes, lift
the dispenser mechanism (with springs) out of the cabinet
high enough for access to the bottom of the springs, or
lift the dispenser out and place on oor.
c. Unhook one or more springs from the bottom. Leave the
spring hang for future use. Replace the ten dishes. Repeat this
operation if the dishes are still too high. Place dispenser back
into cabinet.
c. If the dish height is too low, remove all the dishes. Lift the
dispenser out of the cabinet high enough for access to
the bottom of the springs. Hook one or more loose springs
into position. Replace the dishes. Repeat this operation if the
dish height is still too low.
d. Repeat the above operations with more and with less dishes.

Springs

MOBILE NON-HEATED

self-leveling

DISPENSER

Dish Guide

Top Cap

Lower

Spring

Ring

Carriage

Assembly

CLEANING OF UNIT

a. Lift self-leveling mechanism from square tube and clean
as desired.
b. Wash inside and outside of cabinet with a mild soap and
water. Dry thorougly.

For more information, call Lakeside Customer Service at 800.558.8565

Email: [e-mail]  www.eLakeside.com