Lakeside Foodservice E6200 Installation Manual

INSTRUCTIONS

For Models

E6200, E6205, E6206, E6207, E6208,
E6209, E6210, E6211, E6212

OPERATION

TM

EXPRESS HEAT

MOBILE HEATED

self-leveling

DISPENSER

CAUTION: The Express Heat Plate Warmer/Dispenser is
designed for back-of-the-house operation to produce very hot
plates. It is not designed for heating/dispensing in public
areas. Avoid touching the top cabinet surface during
operation. Care must also be taken when handling hot plates.

The Express Heat features a blower to heat plates faster and more
evenly. The unit’s blower turns on when the cabinet’s power
cord is plugged into a live electrical outlet. The blower cannot be
turned o (and will not go ‘o’) while the unit is plugged in.

To turn the heating element on and heat dishes, depress the
On/O button located on the top of the cabinet between the
dispensers. The indicator light will illuminate when the heating
element is powered up in the ‘on’ position (see reverse side).

Round stainless steel dish covers are provided to retain heat and
allow the unit to heat plates more eciently. Place the covers over
the dispensers while plates are heating after the heating element
is turned on.

DISPENSING HEIGHT ADJUSTMENT

Dish diameter and weight determine how many springs should
support your dishes. To insure smooth operation, use an equal
number of springs on both sides of the dispenser. Always
unhook lower end of springs only. Leave unused springs hang by
top hook for future use.

Springs

Lower

Spring

Ring

Dish Guide

Top Cap

Unused

Spring

(hanging)

Carriage

Assembly

Use the following chart as a guide to determine approximately how
many springs to use.

Dish Size Springs Required

5¾” to 6½” Diameter 3 to 7
6¾” to 7¼” Diameter 7 to 9
7½” to 8” Diameter 9 to 11
8¼” to 9” Diameter 10 to 13
9¼” to 10” Diameter 12 to 16
10¼ to 12¼ Diameter 16 to 22

a. Place six to ten dishes into the unit directly on top cap.
b. If the dishes are above the top of the dish guides, one or more
of the springs must be unhooked. Remove the dishes, lift
the dispenser mechanism (with springs) out of the cabinet
high enough for access to the bottom of the springs, or
lift the dispenser out and place on oor.
c. Unhook one or more springs from the bottom. Leave the

(Continued)

ADDITIONAL INFORMATION ON REVERSE SIDE.

HEIGHT ADJUSTMENT (continued)
spring hang for future use. Replace the six
dishes. Repeat this operation if the dishes are
still too high. Place dispenser back into cabinet.
d. If the dish height is too low, remove all the
dishes. Lift the dispenser out of the cabinet
high enough for access to the bottom of the
springs. Hook one or more loose springs into
position. Extra springs are attached unhooked
for this purpose. Replace the dishes. Repeat this
operation if the dish height is still too low.
e. Repeat the above operations with more and
with less dishes.

EXPRESS HEAT

MOBILE HEATED

self-leveling

DISPENSER

THERMOSTAT ADJUSTMENT

The thermostat is located under the small cover plate on the side of the cabinet, and is preset at the highest setting for quick
heating. To obtain adjust the thermostat:

a. Locate the thermostat adjustment wheel by sliding the cover plate to one side (see below).
b. Dial the wheel to a lower number to decrease the temperature.
c. Run the cabinet heater with a full load of dishes to determine the cabinet’s set temperature. The cabinet may take up to
two hours to heat plates to maximum desired temperature.

CLEANING OF UNIT

a. Unplug unit from electrical source and allow it to cool to room temperature.
b. Lift self-leveling mechanisms from cabinet and clean as desired.
c. Remove any debris from the interior of cabinet by sweeping it to the clean-out hole on the floor of the cabinet.
d. Wash inside and outside of cabinet with a damp cloth. Avoid getting the blower/heater mechanism wet.
Dry thorougly.
e. Reinsert self-leveling mechanisms into cabinet.
f. Run the unit empty for fifteen minutes to facilitate drying and evaporate any chemical residue before reloading
with dishes.

TM

On/Off Switch

Thermostat

Dial

For more information, call Lakeside Customer Service at 800.558.8565

Email: [e-mail]  www.eLakeside.Foodservicecom