lakeair LA-Table M(120v), LA-Table M(230v), LA-Table H(120v), LA-Table H(230v) Operating And Service Manual

Table Media or Hepa air cleaner

Operating and Service Manual

LA-Table M (120v)
LA-Table M (230v)
LA-Table H (120v)
LA-Table H (230v)

VI. LAKEAIR MEDIA OR HEPA

AIR CLEANER

1 YEAR LIMITED WARRANTY

The complete LakeAir Media or Hepa Air
Cleaner is warranted by Air Aware Inc. to the
original purchaser to be free from defects in
material and workmanship under normal use
and service for a period of one year from the
date of purchase. Air Aware’s liability is to
be limited to repairing or replacing such
products during the warranty period at its
option, providing the product is sent prepaid
to Air Aware Inc. or an Authorized Service
Center and is deemed to the satisfaction of
Air Aware Inc. to be defective in any part or
portion.

This warranty is in lieu of any other warranty
expressed or implied and of all other
obligations or liabilities in connection with
the sale of the described LakeAir Media or
Hepa Air Cleaner. In no case will any claim
for consequential damages or labor expenses
be allowed. This warranty does not apply to
a LakeAir Media or Hepa or any part thereof
which has not been operated in accordance
with the operating instructions herein
contained; where components or other
accessories not compatible with the LakeAir
Media or Hepa Air Cleaner have been used
or attached to it; which has been subject to
accident, unauthorized alteration, abuse,
damage by flood, fire or acts of nature.

User’s Responsibility

Please Note: Your warranty is subject to user

responsibility. Some items and some
conditions resulting from causes other than
manufacturing defects are the responsibility
of the user of the LakeAir Media or Hepa Air
Cleaner and are not covered by the warranty.
These are:

1. To operate and maintain according to
instructions.

2. Periodic checking and cleaning of unit.
Failure to clean or replace filter when needed
will void warranty.

3. Proper use of controls must be maintained
or warranty will be voided.

4. Damage to unit from unsatisfactory
operation because of blowing fuses,
inadequate electrical service or operation on
power supply other than that indicated on the
rating plate, or incorrect electrical protection
devices used.

5. Damage occurring during transportation
or resulting from improper handling.

6. Damage due to accident or resulting from
alteration or tampering.

7. Misapplication of product.

TABLE OF CONTENTS

I. Unpacking and Operating Instructions

II. Maintenance Instructions

III. Repair

IV. Specifications

V. Replacement Parts

VI. Warranty

IV. SPECIFICATIONS

LA-Table M
120v

LA-Table M
230v

LA-Table H
120v

LA-Table H
230v

Input Voltages: 120v 60Hz

5 Amp

230v 60Hz
3 Amp

120v 60Hz
5 Amp

230v 60Hz is
Available
3 Amp

Cleaning Capacity: Low: 400 cfm

High: 600 cfm

Low:
High:

Low: 350 cfm
High: 500 cfm

Low:
High:

Actual Size: 21.5” x 27.5 x 23” 21.5” x 27.5” x 23”

Actual Weight: 75 lbs kg 78 lbs kg

Shipping Size: 30” x 23.5” x 25”x 30” x 23.5” x 25”

Shipping Weight: 89 lbs kg 92 lbs kg

V. REPLACEMENT PARTS LIST

MODEL ELECTRONIC LA-TABLE

Part #

Description

10080 LA-TABLE 120v POWER SUPPLY
10180 LA-TABLE 230v POWER SUPPLY
495101 MAX FAN BLADE
497503 120v MOTOR
497504 230v MOTOR

Common Parts

10112 LA-TABLE 120v/230v COMPLETETE CELL
ASSEMBLY
497606 120V TRANSFORMER w/TERMINALS
497607 230V TRANSFORMER
497567 MICRO SWITCH ASSEMBLY
20112 CORD ASSEMBLY
497572a VOLTAGE DOUBLER
497612 ROCKER SWITCH
497592 LIGHT 120V/230V
497546 FUSE HOLDER
497547 5 AMP FUSE (1 REQUIRED, 1 SPARE IN
FUSE HOLDER
490051 PREFILTER SCREEN
499072 CARBON FILTER
10130 ION WIRES w/ SPRINGS & “S”

HOOKS (6 EACH)
40137 ION INSULATORS WITH SCREWS
(4 EACH)

I. UNPACKING AND OPERATING

INSTRUCTIONS

In order to operate your LakeAir Air Cleaner properly, it is necessary to
remove plastic packing material from the prefilter and the media or Hepa filter
inside the unit. (Remove plastic packaging material from the optional carbon
after filter inside the unit if included as well).

1. Position the unit in a desired location.

2. To open the table cabinet, pull lightly on the drawer handle.
Unhook the grid cap and loosen the thumb screws. Remove the prefilter
screen, optional carbon after filter if included, and the media or Hepa filter by
lifting the filters straight up.

3. Remove all plastic material from filters and discard.

4. Replace the prefilter with the mesh side towards the motor before inserting
the media or Hepa filter. The arrows on the media or Hepa filter should always
point towards the fans. Then replace the carbon after filter if included.
Tighten the thumb screws. Close the drawer cabinet. Note: The drawer must
be closed securely or the unit will not operate.

5. Plug the unit into a proper line voltage. Turn the unit on, with the three­position rocker switch on the side of the unit. Depress the button to activate
the unit on the desired speed: High, Low, or Off (center, flat position). The
indicator light will illuminate when any of the “on” modes are selected,
indicating there is electrical power to the unit. To shut the unit off, simply
push the button to its center (flat) position.

III. REPAIR

Before attempting any repairs on your Air Cleaner, check the following items first.

1. Check fuse.

2. Check for electrical power to unit.

3. Check that the media filter, prefilter screen, Hepa filter, and
carbon filter are “CLEAN”, and properly installed into the Air
Cleaner.

INDICATOR LIGHT DOES NOT WORK

1. Check fuse.

2. Plug power supply into the proper receptacle.

FAN MOTOR DOES NOT RUN

1. Check power source and fuse.

Repair work should only be performed by a trained, experienced serviceman.
Check with your dealer for the repair station in your area. If unable to locate a
qualified serviceman, contact the factory at the address or telephone number listed
below for authorization to return the unit to the factory. DO NOT RETURN

UNIT TO FACTORY WITHOUT AUTHORIZATION.

.

II. MAINTANENCE

Your LakeAir Air Cleaner is a high quality, precision piece of equipment
designed for long years of satisfactory performance. Adhere to a regular
maintenance schedule and no problems should occur. This unit should be
checked periodically for “dust load” and replace filter regularly. Under regular
conditions the media filter should be replaced every 3-4 months. Under more
severe conditions more frequent replacement may be required. The Hepa filter
with the integrated carbon after filter should be changed every 6-9 months
depending on the pollutants in the air. Care should be taken to keep the rest of
the unit clean as well. Note: Change filter when noticeably dirty as it

damage the motor if it is not changed frequently enough. To obtain
maximum efficiency from your LakeAir Media or Hepa filter Air Cleaner
it must be kept clean.

DISASSEMBLY AND CLEANING

1. Turn off the air cleaner and disconnect line cord from outlet.

2. Open the drawer containing the filters and loosen the thumb screws
to remove the carbon after filter, media or Hepa filter, and prefilter.

3. CLEAN THE PREFILTER SCREEN by wiping it off with a damp
cloth.

CLEAN THE CARBON AFTER FILTER by vacuuming or brushing.
DO NOT WASH. Replace carbon after filters as needed,
approximately every 3-4 months depending on the pollutants in the air.
(This filter should also be replaced when there is an indication that it is
no longer absorbing odors. Only the prefilter is washable. Do Not
wash the media, Hepa, or carbon after filter). NOTE: The Hepa filter
includes integrated carbon after filter. The Hepa filter is only
replaceable, there is no cleaning necessary. The Hepa filter needs
to be replaced approximately every 6-9 months depending on the
pollutants in the air. Discard used filters.

4. For the Media: Replace the prefilter, media filter, and the optional
carbon after filter if included.
For the Hepa: Replace the prefilter and the Hepa integrated carbon
after filter.

NOTE: TO INSURE PROPER OPERATION, FILTER(S) SHOULD BE
REPLACED AT REGULAR INTERVALS. FAILURE TO REPLACE MEDIA
OR HEPA FILTER WILL VOID THE WARRANTY.

Thumbscrew

Carbon after filter

Prefilter

Grid Cap

Carbon after filter

Media or Hepa

filter

Prefilter